Publicidad
Idiomas disponibles
Idiomas disponibles
4. PLACEMENT OF THE BATTERY
The unit incorporates a RTC (Real-time clock) whose function is to maintain the current time. In order to keep the RTC powered even
if the unit is turned off, a 3V lithium battery type CR2032 supplied with the unit must be inserted.
It is advisable to replace the battery of the device at least every 5 years.
Safe handling with batteries:
•
Warning! Improper use of battery may lead to explosion. Replace the batteries with the same or equivalent type only.
•
Batteries may endanger life if swallowed. If a battery is swallowed, seek medical assistance immediately.
•
Before inserting the batteries, check whether the contacts in the device and batteries are clean and, if necessary, clean
them.
•
Only use new batteries.
•
Do not use rechargeable batteries
•
Never try to recharge normal batteries. There is a risk of explosion!
•
Never expose batteries to heat sources (e.g. radiators) or direct sunlight. There is an increased risk of leakage!
•
Never short-circuit the batteries.
•
Never throw batteries into a fire.
•
Do not disassemble or deform batteries.
•
If the equipment is not going to be used for long periods, remove the battery.
•
Remove leaking batteries from the device immediately. If battery acid leaks out it is essential to avoid contact with the skin,
eyes and mucous membranes! If the acid does come into contact with skin, immediately rinse the affected areas with plen-
ty of clear water and
•
Remove exhausted rechargeable battery from the device immediately! There is an increased risk of leakage.
•
Do not throw used batteries into the household waste. The batteries must be deposited in a collection point for used bat-
teries.
Battery
procedure:
placement
1)
Disconnect the power supply to the device.
MI2-700ETH 5.2.002 version
MI2-700ETH
consult a doctor immediately. There is a risk of acid poisoning and acid burns!
1)
Converter of 2 analogue audio signals
to 2 channels of streaming via IP
R+D Department
6
Publicidad
