Publicidad
Idiomas disponibles
Idiomas disponibles
CONTROL PANEL INSTRUCTIONS
level display
time display
level down
expression mode
two in one mode
PRODUCT PARAMETER INFORMATION
Model
Input Power
Suction Strength
Charging Time
Rated Power
Output Power
Battery Capacity
Running Time
MODE
Expression
Two-in-one
Dual-frequency
ASSEMBLY INSTRUCTIONS
01
02
03
level up
power on/off
mode selector
dual-frequency mode
5018
100-240V, 50/60Hz
=<0.038MPa
—150 mins
5W
5V/1A
1100 mAh
—120 mins
LEVEL RANGE
1-9
1-9
1-9
01. Insert the duckbill valve into the interface of the
bowl and install the breast shield to the bowl. Please
note that it is installed place when the milk outlet of
the bowl fits the protrusion of the breast shield.
02. Choose 28 mm breast shield or 24 mm or 21 mm
insert, depending on your needs.
03. Install the pump unit-silicone gas storage-storage
bowl as shown in the above picture.
NOTE: When using single pumping, please make sure
the silicone plug is inserted tightly.
When using double pumping
1. Pull out the silicone plus
2. Connect the tubing to the main pump unit and the
collection cup
OPERATING INSTRUCTIONS
Maintain proper posture and relax. Place the breast
shield on your breast with the nipple in the centre.
Press and hold
on top of main pump unit to turn on
the power. The digital display screen will turn on and
the 1 minute timer will start once the main pump unit
is being turned on. If the main pump unit is idle for 1
minute, it will turn off automatically.
Press
to select desired mode.
Select
to enter EXPRESSION MODE. Touch + to
increase suction strength, - to reduce suction strength.
Suction strength can be set between L1 and L9. Each
setting offers a different pumping strength, from weak
to strong.
Select to enter TWO-IN-ONE MODE. The breast pump
will provide a pumping cycle of massaging eight (8)
times and pumping once (1). This is a good way to
relieve pain in full breasts and to produce plenty of
breast milk in little time. Touch + to increase suction
3
Publicidad
