Battery Charge - Brigmton BSK-1000-B-N Manual De Instrucciones

FUNCTIONING
Before driving, check and make sure that all locks (handlebar and base) are
properly tightened, the release lever and the folding bar are in the correct
position, the tires are adequately inflated and equipped with the necessary
protections.
Press the power button on the screen for 3 seconds. Verify that the battery
is charged. Select the desired speed level (it is recommended to start with
the lowest level).
Push the skate manually to start rolling and accelerate. Stop using the
brake lever. IMPORTANT: Do not apply the brake strongly when driving at
high speeds, it could cause accidents.
Once finished, turn off the unit by pressing the power button for 3 seconds.
The screen will turn off automatically when you do not use it in 3 minutes.
The screen shows the following information by pressing the MODE button:
- Total distance
- Travel distance
- Remaining distance
- Weather
- Mistakes
- Speed
Press ON / OFF and MODE together to access the configuration menu. The
configuration menu options are for the Technical Assistance Service, please
consult the Technical Service to use this menu. Do not modify these options
if it is not under review/indication.

BATTERY CHARGE

The battery can be charged directly on the skate. To charge the battery,
first turn the unit off, connect one end of the charger to the charging input
of the skate and the other end to a power outlet. A red light will light up
and once it is charged it will turn. NEVER use the skate while charging the
battery.