Battery Maintenance - Brigmton BSK-1000-B-N Manual De Instrucciones

This skate requires maintenance of all its components, which suffer wear
and tear due to the use of the same and is not covered by the warranty.
CLEANING
To clean the skate, use a damp cloth. If you need to scrape dirt, use a soft
brush and then a damp cloth. In case the dirt is very sticky you can use a
little toothpaste. Remember to wipe with a damp cloth after this.
Be sure to keep the skid off while cleaning and make sure you cover the
load inlet to avoid problems with the electronic components.
Do not use alcohol, gasoline, kerosene or other volatile or corrosive
chemical components. This can damage both the appearance and the
internal structure of the scooter. Also, do not use a pressure water gun or
running water.
CONSERVATION
Store the scooter in a cool, dry environment when not in use. Avoid leaving
it outside, since it is not manufactured for use in wet areas, near corrosive
agents such as seawater, ports, etc. It is also not recommended to expose it
to high temperatures caused by direct sunlight for a long time.

BATTERY MAINTENANCE

Do not exceed the permitted operating temperature, above or below, for a
prolonged period of time. For example, do not leave the scooter in a car in
the sun in summer or place the batteries near the fire, etc.
Avoid completely discharging the batteries, it is better to charge them
while there is still power in them. This will prolong the life of the battery.
Also if you drive the skate in very cold or warm areas, you can decrease the
time of use of the batteries. It is not a failure of the batteries, but it is their
normal behavior.
Important: Even with fully charged batteries, by not using it for a
prolonged period, you can download them.
It is forbidden to disassemble the battery compartment. Only its
manipulation in Official Technical Services or adhered Workshops is
allowed.