FUXTEC E1KS20 Instrucciones De Uso Originales página 37

Drop notch (approx. 3-5 cm).
Never saw through the log completely. The area (C) serves as a hinge and ensures a defined direction
of fall. When felling, stand only to the side of the tree to be felled! There is a risk of life-threatening
injuries (see following illustration)!
Working on logs lying flat on the ground
Cut the log in half, then turn it over and saw through from the opposite side. Make sure that the saw-
bar does not touch the ground when sawing through the log (see following illustration)!
We recommend supporting logs to be sawn through on sawhorses. If this is not possible, the log
should be lifted and supported with the help of the supporting branches or via support blocks.
In area A, first cut to about one third of the log diameter from top to bottom, then make the final
cut from bottom to top. In area B, first cut to about one third of the log diameter from bottom to
top, then saw through from the top (see following figure).
Important: Do not saw logs that are under tension! Splintering wood or a tilted saw-bar can cause
serious injuries!
Original manual FUXTEC 20V FX-E1KS20 rev03
V e r l e t z u n g s g e f a h r !
!
G e r ä t e s c h ä d e n !
!
37