FUXTEC E1KS20 Instrucciones De Uso Originales página 38

Original manual FUXTEC 20V FX-E1KS20 rev03
Branch removal
Always work on the side opposite the branch in question.
Start at the bottom of the log and work your way up.
Saw in the branch 10-15 cm from the base of the branch from bottom to top to 1/3 of the branch
diameter.
Saw through the branch a little further out from top to bottom.
Make a cut close to the trunk. Make the cut from top to bottom.
When delimbing lying logs, always saw off the branches that protrude freely into the air first. Do not
cut off support branches until the log has been sawn in lengths (see following figure).
Caution: Branches that are resting or under tension can wedge the saw-chain in the wood!
Maintenance and care
Attention: before any work on the power tool, remove the battery from the device.
Sharp cutting teeth ➔ Wear protective gloves!
Do not use water or liquid detergents.
- Clean the hedge trimmer after each use with a dry cloth or, in the case of heavy
Soiling with a brush.
- Never spray the device with water.
- Keep the contacts of the battery and the device clean and dust-free.
- Remove the chain cover and then use a soft brush to remove debris from the guide bar, saw chain,
sprocket and chain cover.
- The saw-chain must not sag, but it should be possible to pull 2-3 millimetres off the saw-bar in the
middle of the saw-bar.
38