Publicidad
Idiomas disponibles
Idiomas disponibles
3. IDENTIFICATION OF PARTS
Check that all the items shown in the picture are present in the packaging: if any items are found to be missing or
damaged, do not proceed with assembly or commissioning in any way and contact your dealer to have the original
equipment restored.
4. COMMISSIONING
1. Mount the base on the main body by fastening it with the 4
screws supplied as shown in the figure opposite.
2. Unscrew the ring nut securing the rear grille (11) from the motor
shaft (5) by turning it counter-clockwise.
3. Insert the rear grille (12) on the motor shaft (5) so that the handle
on the back of it is facing upwards and the two interlocking pins (A-
B) fit over the vertical holes in the rear grille. Screw in the fixing ring
nut (11) by turning it clockwise.
4. Insert the fan (10) on the motor shaft (5) and secure it by turning
the fixing ring nut (9) counter-clockwise.
5. Open the clips of the front grille (8) and position it on the rear
grille (12) so that the logo on the central stud is in a horizontal
position parallel to the floor.
6.Once the right position has been found, close the clips and insert
the grille securing screw (7).
5. USE
Place the fan on a flat, dry and stable surface and plug the fan into a suitable power socket. Select the desired
speed by pressing the buttons on the control panel (4):
0 =off 1 =minimum speed 2 =medium speed 3 =maximum speed
OSCILLATION:
Automatic right-to-left oscillation is achieved by pressing the knob (6) located on the motor head. To deactivate it,
turn the knob back upwards.
VERTICAL TILTING
It is possible to orient the fan head vertically by choosing the desired angle.
Simply adjust the fan head by gently moving it up or down according to the
desired angle.
1
Screws (4)
2
Base
3
Main body
4
Control panel
5
Motor shaft
6
Oscillation knob
7
Securing screw
8
Front grille
9
Fan fixing ring nut
10
Fan
11
Rear grille fixing ring nut
12
Rear grille
13
Motor body
A
Rear grille interlocking pins
and
B
9
Publicidad
