Publicidad
Idiomas disponibles
Idiomas disponibles
The operation of any lawn
mower can result in foreign
objects thrown into the
eyes, which can result in
severe eye damage.
Always wear safety glasses or eye
shields while operating your lawn mower
or performing any adjustments or repairs.
We recommend standard safety glasses
or a wide vision safety mask worn over
spectacles.
HOWTO
USE YOUR LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory
for optimum performance. Speed is not
adjustable.
ENGINE ZONE CONTROL
_,CAUTION:
Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not under any
circumstances attempt to defeat the
function of the operator control. The blade
turns when the engine is running.
• Your lawn mower is equipped with an
operator presence control bar which
requires the operator to be positioned
behind the lawn mower handle to start
and operate the lawn mower.
DRIVE CONTROL
• Self-propelling
is controlled by holding
the operator presence control bar down
to the handle and pushing the drive
control lever forward until it clicks; then
releasing the lever.
• Forward motion will stop when the
operator presence control bar is
released. To stop forward motion
without stopping engine, release the
operator presence control bar slightly
until the drive control disengages. Hold
operator presence control bar down
against handle to continue mowing
without self-propelling.
• To keep drive control engaged when
turning corners, push down on handle
and lift front wheels off ground while
turning lawn mower.
_resencecontrolbar
Drive
contml
TO ADJUST
CUTTING
HEIGHT
Raise wheels
for low cut and lower
wheels
for high cut, adjust
cutting
height
to suit your requirements.
Medium
position
is best for most lawns.
•
To change
cutting
height,
squeeze
adjuster
lever toward
wheel.
Move
wheel
up or down to suit your require-
ments. Be sure all wheels
are in the
same setting.
NOTE:
Adjuster
is properly
positioned
when plate tab inserts
into hole in lever.
Also, 9-position
adjusters
(if so equipped)
allow
lever to be positioned
between
the
plate tabs.
LOWER WHEELS FOR HIGH CUT
_._
Plate tab ._'O._IF'
RAISE WHEELS FOR LOW CUT
Lever
TO CONVERT MOWER
Your lawn mower was shipped ready to be
used as a mulcher. To convert to bagging:
• Lift rear door of the lawn mower and place
the grass catcher frame hooks onto the
door pivot pins.
• To convert to mulching operation, remove
grass catcher and dose rear door.
_CAUTION:
Do not run your lawn mower
without rear door closed, clipping
deflector or approved grass catcher in
place. Never attempt to operate the lawn
mower with the rear door removed or
propped open.
Rear
Grass
catche(
handle
Catcher frame
TO
DRIVE
ENGAGE
CONTROL
DRIVE CONTROL
DISENGAGED
7
Publicidad
