Mounting Of Cutters; Capstan Operation - Walter ICECUT100 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

LIVE, NEUTRAL and GROUND. If it becomes necessary to fit an extension cable from the power source, care must
be taken in using a cable of adequate capacity. Failure to do so will result in a loss of traction by the magnet and a
reduction of power from the motor.
Assuming the correct AC voltage conditions are used, it is recommended not to exceed the following extension
lengths:
For 120V supply: 3.5metres of 3 core x 1.5mm²

12) MOUNTING OF CUTTERS

ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE CHANGING CUTTERS.
The machine has been made to accept cutters having 19.05mm (3/4") dia. Weldon shanks. The following
procedure is to be used when mounting cutters:
Lay the machine on its side with feed handles uppermost; ensuring arbor is wound down to its lowest point to
enable access to socket screws.
Take appropriate pilot and place through the hole in cutter shank. Insert shank of cutter into bore of arbor,
ensuring alignment of two drive flats with socket screws.
Tighten both screws using hexagon key.

13) CAPSTAN OPERATION

The quick release capstan is a feature that offers the user a simple dual side operation.
To remove the capstan, simply do the following:
1. Press in the central button on the capstan hub, holding onto the capstan arms.
2. With the button pressed in, pull the capstan away from the main body, holding on to the capstan arms.
3. Re-insert the hexagonal shaft into the hexagonal slot to attach the capstan.
11

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Icecut20039-d 10039-d 200

Tabla de contenido