Gear Selection; Magnet Detection; Accudrill Technology - Walter ICECUT100 Manual De Instrucciones

8) GEAR SELECTION (ICECUT200 only!)
The ICECUT200 magnetic drilling unit is fitted with a 2 speed gearbox. The gear is used to reduce the output speed
when using larger cutters.
Up to 30mm diameter cutters, gear position 1 should be used.
30 – 40mm diameter cutters, gear position 2 should be used.
Gear position 1: High speed,
Gear position 2: Low speed, from
up to 30mm diameter cutters
30 to 40mm diameter cutters

9) MAGNET DETECTION

It is advised that, when working on thin material, a packing piece should be used to increase the material thickness
under the magnet. Working on thin material without a packing piece will reduce the magnet holding force. It is
advised that the drill is to be operated on ferromagnetic material 8mm thick and above. Damage to the magnet base,
such as pitting, will affect the strength of the magnet holding force.

10) ACCUDRILL TECHNOLOGY

Designed for you, to get the most out of your machine and your annular core cutters. The ACCUDRILL Technology
lest you knowthanks to an easy-to-read LEDindicator when you are drilling with too much force, which will damage
the machine and the cutters. Allow the cutter to do the work and you will find that a much smoother hole and faster
drilling time is achieved.
9