Panasonic CS-UE9PKE Manual De Instrucciones página 7

To select operation mode
AUTO mode - For your convenience
• During operation mode selection the power
indicator blinks.
• Unit selects the operation mode according to the
indoor intake temperature and remote control
temperature.
HEAT mode - To enjoy warm air
• In heat mode, it may take a while for the unit to
warm up.
COOL mode - To enjoy cool air
• To reduce power consumption during COOL
mode, use curtains to screen off sunlight and
outdoor heat.
DRY mode - To dehumidify the environment
• Unit operates at low fan speed to give a gentle
cooling operation.
To adjust vertical airflow
direction (5 options)
(
Remote control display
• Keeps the room ventilated.
• In COOL mode, if AUTO is set, the louver swings
up/down automatically.
• In HEAT mode, if AUTO is set, the horizontal
louver fix at predetermined position.
• Do not adjust the louver by hand.
To achieve temperature
quickly
• This setting enables the desired set temperature
to be reached quickly.
NOTE: POWERFUL and QUIET operations can
not be activated at the same time.
Operation conditions
Use this air conditioner under the following temperature range.
Temperature(°C)
Maximum
COOLING
Minimum
Maximum
HEATING
Minimum
NOTICE: • This model is not suitable for 24 hours non-stopping operation in heating mode below
-10°C. When the outdoor temperature is below -10°C and you use this model out of above
conditions, the outdoor unit might be frozen up and stop operation for protection control.
F568882-en.indd 7
)
Indoor Outdoor
*DBT *WBT *DBT
32 23 43
16 11 16
-
30 24
-
16 -10
To set the timer
2
A
1
SELECT
• To turn ON the unit at a preset time. Set the
timer while the unit is OFF.
• To turn OFF the unit at a preset time. Set the
timer while the unit is ON.
Press once to select timer.
1
2 Press repeatedly to set your desired
time.
3 Press once to confirm.
• To turn ON and then turn OFF the unit at
preset time. Set the timers while unit is OFF.
• To turn OFF and then turn ON the unit at
preset time. Set the timers while unit is ON.
1
Press twice to select timers.
2
Press / repeatedly to set your
desired time.
3
Press once to confirm.
• Press the button again to cancel timer
operation.
• The timer will also be cancelled when you
press button.
• The timer indicator of indoor unit will light up
during timer operation.
• When ON Timer is set, the unit may start
earlier before the actual set time in order to
achieve the desired temperature on time.
• If timer is cancelled manually or due to power
failure, you can restore the timer again by
repeating steps above (once power is resumed).
DBT: Dry bulb temperature
*WBT
WBT: Wet bulb temperature
26
11
18
-6
B
3
SET/CANCEL
2012-11-7 15:44:25
7