san ignacio 39204 Manual De Instrucciones página 12

1.08L of water).
2. Before using the blender, you must clean the glass jar with water as follows:
a) Turn the rotary switch to the OFF symbol in order to make sure the unit is turned
off.
b) Remove the lid and the measuring cup.
c) Put 800ml of water into the glass jar and turn on the appliance, then turn it off
when working for about 10-20 seconds and then empty the glass jar.
3. Blend other foods as follows:
a) Turn the rotary switch to the OFF symbol in order to make sure the unit is turned
off.
b) Put small pieces of food into the glass jar, then add some water properly but not
higher than the maximum level, then close the lid and the measuring cup. Please
note there is a micro-switch with the blender that makes the blender not be able to
work until the glass jar is installed onto the main body properly.
c) Turn the rotary switch to the required speed position.
4. If you want to crush ice cubes, the quantity of ice in the glass jar must not be more
than 12 pieces (about 20x20x20mm). Use the ice crushing program for it.
CAUTION:
1. An over-filled jar can block the operation. Please turn off the unit and pull out the plug,
then take out some food before operating the device again.
2. Do not use the unit continuously more than 40 seconds.
3. When the blender is in the state of idle operation, e.g. there is no food in the glass jar,
you must not use the appliance.
3. MAINTENANCE & CLEANING
• Before cleaning, you must switch off the appliance and unplug it from the socket.
• Do not clean the main body, the power cord or the plug with water.
• Clean the main body/power cord/plug with a soft, wet piece of cloth and some
mild cleaning agent.
• Fill the glass jar half-full with warm water and a little cleaning agent. Let the unit