DeWalt DCMWP134 Manual página 58

EnGLIsh
Mulching (Fig. N)

DANGER: Turn unit off and remove safety key and
battery packs.
1. To operate mower in mulching mode, remove the grass
collection bag 22 or side discharge chute
2. Lift the rear door cover
fully into the mower.
3. Ensure the pins 35 on the mulching plug
slots 36 on the mower as shown in Fig. N.
4. Be sure rear door cover
Side Discharge (Fig. O)

DANGER: Turn unit off and remove safety key and
battery packs.
1. To operate mower in side discharge mode, remove the grass
collection bag 22 .
nOTE: If installed, remove the mulching plug
2. Lift the rear door cover
chute 25 onto the mower as shown in Fig. O.
3. Release the rear door cover
discharge chute 25 is secured in place before operating
the mower.
Adjusting Mower Height (Fig. P)
The height of cut is adjusted by the cut height adjust lever
nOTE: If you are not sure which height to mow at, begin mowing
with the cut height adjustment lever
setting and adjust height down as needed for your application.
To Set the Height of Cut
1. Pull the cut height adjustment lever
notch .
37
2. Move the cut height adjustment lever
of the mower to raise the height of cut.
3. Move the cut height adjustment lever
of the mower to lower the height of cut.
4. Push the cut height adjustment lever
locking notches .
37
OPERATION

DANGER: To reduce the risk of serious personal
injury, turn unit off and remove the safety key and
battery packs before making any adjustments or
removing/installing attachments or accessories. An
accidental start-up can cause injury.
Proper Hand Position (Fig. Q, R)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
56 56
25 .
and slide the mulching plug
21
24 engage the
21 is closed.
.
24
21 and hook side discharge
and ensure the side
21
20 positioned at the highest
out of the locking
20
20 towards the rear
20 towards the front
into one of the
20
DCMWP134
Proper hand position requires both hands grasping the main
handle and bail handle
4
DCMWsP156
Proper hand position requires both hands grasping the main
handle 4 and bail handle
24
mode; and both hands grasping the main handle, bail handle,
and self drive lever
shown in Fig. R.
READ THIS INSTRUCTION MANUAL
BEFORE OPERATING YOUR MOWER
Refer to Fig. A at the beginning of this manual for a complete list
of components. Save this manual for future reference.

DANGER: Sharp moving blade. Do not operate the
mower in mulching mode if the rear door is not closed
under spring tension as serious injury could result. Take
your mower to the nearest service center for repair.

DANGER: Do not operate mower unless handle is locked
into position.

DANGER: Sharp moving blade. Never operate the
mower in bagging mode unless the bag lugs on the grass
collection bag are seated properly on the mower and the
rear door rests firmly against the top of the grass collection
bag as serious injury could result.
.
20

DANGER: Sharp moving blade. Do not operate the
mower in side discharge mode unless the rear side
discharge chute is properly installed with the rear door
cover resting firmly against it.

WARNING: Let the mower work at its own pace. Do
not overload.
Installing and Removing the Battery Packs
(Fig. S)

DANGER: MAKE CERTAIN THE SAFETY KEY IS
REMOVED TO PREVENT ACTUATION BEFORE
REMOVING OR INSTALLING BATTERIES.
This mower is designed to operate on two battery packs of
equal capacity. The mower will not operate on a single battery
pack, and If using different capacity battery packs, the smaller
capacity battery pack, when depleted, will cause the unit to
turn off.
The mower will turn off and the overheat indicator
if the battery pack reaches the high temperature limit, which
can be caused by cutting heavy grass. If this occurs, allow the
battery pack to cool and then resume cutting with the mower
deck set higher.
nOTE: For best results, make sure the battery packs are
fully charged.
To Install the Battery Packs
1. Lift and hold the battery port cover
battery port
2. Slide a battery pack
an audible click is heard (Fig. S). Repeat for the second
battery pack
as shown in Fig. Q.
8
8 together when not in self-propel
9 together when in self-propel mode as
19
38 .
into the battery port
26
26 .
will blink
13
up to expose the
until
38