Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
_
j.
SCHEDULE
_o_
_
4_
I-
o
Lubrication
q_
t_
o
Clean equipment
_
q_
Check engine oil
uJ
Change engine oil
_
<_
z
Service air cleaner
z
Service spark plug
_
Service muffler
'_
Clean engine
,q_
GENERAL R ECOMMENDATIONS
Always observe safety rules when performing any
maintenance.
The warranty on this Yard Vacuum does not
cover items that have been subjected to operator
abuse or negligence. To receive full value from
the warranty, operator must maintain the
equipment as instructed in this manual.
Some adjustments will need to be made
periodically to maintain your equipment properly.
Follow the maintenance schedule.
Periodically check all fasteners and make sure
they are tight.
WARNING:
Always stop the engine and
disconnect
and ground the spark plug
wire before performing any maintenance
or adjustments.
LUBRICATION
Wheels- Place a few drops of SAE 30 oil on each
shoulder screw once a season.
Refer to Figure 6.
Nozzle height adjustment
levers- Lubricate
nozzle height adjustment levers with light oil.
Refer to Figure 6.
Locking Rod- Lubricate the lock rod and
compression springs which attach to the
mounting bracket. Refer to Figure 4.
CLEAN EQUIPMENT
Clean the Yard Vacuum thoroughly after each
use.
Wash the bag periodically with water. Allow to
dry thoroughly in the shade.
If the flail screen becomes clogged, remove and
clean as instructed in the SERVICE AND
ADJUSTMENT section.
NOTE: Cleaning with a forceful spray of water is not
recommended
as it could contaminate
the fuel
system.
CHECK ENGINE OIL
Remove oil fill dipstick.
Check oil level on dipstick. Level should be at
FULL mark.
Replace dipstick and tighten.
CHANGE ENGINE OIL
Only use high quality detergent oil rated with API
service classification SF, SG, or SH. Select the
oil's SAE viscosity grade according to the
expected operating temperature. Refer to
operation section for viscosity chart.
Stop engine and wait several minutes before
checking oil level. With engine on level ground,
the oil must be to FULL mark on dipstick.
Change engine oil after the first five hours of
operation, and every twenty-five hours
thereafter.
10
Publicidad
Tabla de contenido
