Attaching The Handle - Sears Craftsman 247.770110 Manual Del Operador

Rope
Guide
20-oz. Bottle
of Engine Oil
.Blower
Chute
Handle
lg
uts
Carriage
Screw
Figure 1
IMPORTANT:This unit is shipped without gasoline or
oil in the engine. After assembly, see OPERATION
section of this manual for proper fuel and engine oil
fill-up.
NOTE: Reference to right and left hand side of the
Yard Vacuum is observed from the operating
position. See Figure I.
This Yard Vacuum has been completely assembled
at the factory, except for the handle, bag, and blower
chute. These parts are shipped loose in the carton.
A pair of safety glasses and a 20-oz. bottle of engine
oil are also included in the carton. See Figure 1.
REMOVING UNITFROM CARTON
Cut the corners of the carton.
Remove all loose parts.
Remove packing material.
Lift unit from the rear to discard packing material
from under unit and roll unit out of carton.
Check carton thoroughly for any other loose
parts.
LOOSEPARTSIN CARTON (see
F igure 1)
Handle Assembly
Bag
Blower Chute
Safety Glasses (Not Shown)
A 20-oz. Bottle of Engine Oil
(may be located in bag)
Operator's Manual
DISCONNECTING SPARK PLUG
Before proceeding with assembly of your new Yard
Vacuum, disconnect the spark plug wire from the
spark plug and ground onto the retaining post on the
engine. This will prevent accidental starting of the
engine. See Figure 2.
Retaining Post
O O
Spark
Plug Wire
Figure 2
ATTACHING THE HANDLE
Unfold the upper handle until it aligns with lower
handle. Make sure the rope guide is on the right
side of upper handle. See Figure 1.