KTM DEFCOM 3.1B Manual De Usuario página 11

The DEFCOM 3.1B alarm provides diff erent signals (led, siren and fl ashing of the vehicle in-
dicators) according to the diff erent commands received and diff erent conditions which it is,
following are reported the main signals.
CENTRAL UNIT STATUS
Arming by CARD B9.5
Arming without movement
sensor by CARD B9.5
Arming with
active contact
Initial immunity phase
Pre-alarm phase with ignition
key ON or movement sensor
activation
Alarm cycle (25 sec)
Disarming by CARD B9.5 or
Override Code
Disarming when alarms
have been memorised
Disarming when the
motorcycle's battery is fl at
CARD B9.5 low battery
warning after disarming
SERVICE MODE activated
12. BUZZER ARMING/DISARMING DISABLE
To deactivate the Arming/Disarming Buzzer, it is necessary to contact an installation center
equipped with the PRG007 Programmer or use the smartphone App.
If needs excluding the alarm system for a time period, it's possible enable the SERVICE MODE
modality using its CARD B9.5.
To enable the SERVICE MODE turn ON the motorcycle's key and immediately after press hold
the CARD B9.5 button at least 6 seconds, the feature enabling is indicated by the LED fl ashing
very fast when the motorcycle's key is ON.
To disable the SERVICE MODE turn ON the motorcycle's key and immediately after press hold
the CARD B9.5 button at least 6 seconds, the feature disabling is indicated by the LED goes OFF.
KTM | DEFCOM 3.1B User Manual
11. NOTIFICATIONS
LED
Slow fl ashing
Slow fl ashing
Slow fl ashing
Fast fl ashing
Switches off
Switches off
Switches off
Switches off briefl y
every 6 sec.
Switches off
10 fl ashes after
ignition key ON
Flashing very fast
with ignition key ON
13. SERVICE MODE
DIRECTION
SIREN
INDICATORS
2 Flashes 2 BEEP
Flashes 2 + 1 2 BEEP + 1 BEEP
2 Flashes 2 BEEP + 1 BOOP
-
- 5 BEEP
Flashing Sounds
1 Flash 1 BEEP
- 1 BEEP + 1 BOOP
- 4 BEEP
-
-
-
-
-
11