Publicidad
Enlaces rápidos
Publicidad
Resumen de contenidos para Mount-It! MI-15004
- Página 1 User Manual MI-15004 Please scan this QR code to visit the product page Sit Stand Desk with Drawer...
- Página 2 Thank you for choosing Mount-It Read the entire instruction manual before you start installation and assembly. If you have any questions regarding any of the instructions or warnings, please contact Mount-It! for assistance. CAUTION: Use with products heavier than the rated weights indicated may result in instability causing possible injury. •...
- Página 3 Reset Settings Press and hold the button until a flashing 'S-' is displayed. Press again, and ‘Un’ is Change Display displayed. Press to select it, press to switch between 'IN' (imperial) and 'SI' Height Units (metric), and press to save your choice. Change Collision Press and hold the button until a flashing 'S-' is displayed.
- Página 4 PACKAGE CONTENTS DESKTOP (X1) RIGHT LEG WITH MOTOR (X1) LEFT LEG (X1) TRANSMISSION ROD (X1) FEET (X2) POWER CORD (X1) HARDWARE CONTENTS (x8) (x8) (x2) M8x16 BOLT M6x11 BOLT CABLE MANAGEMENT CLIP (x1) (x1) HEX WRENCH HEX WRENCH EXTRA PARTS (x1) (x2) (x2)
- Página 5 Step 1 Assembling the Legs On a flat and open section of the floor, position the Legs (#B,C) and Desktop (#A) in the configuration shown here. As shown in magnification bubble, connect the Legs to the Desktop using the Bolts (#a) and tighten until secure using the 5mm Hex Wrench (#e). Step 2 Attaching the Transmission Rod Hex wrench...
- Página 6 Step 3 Attaching the Feet Attach Feet (#E) to the Leg (#B,C), using Bolts (#b) and tighten until secure using the 5mm Hex Wrench (#e). Step 4 Connect the Power Lines Connect the Power Lines as shown in the image. Attach the Cable Clip (#c) to the underside of the desktop as needed.
- Página 7 Step 5 Connect the Power Flip the desk assembly over and connect the Power Cable (#F) to a wall outlet. Please follow the reset procedure before operating the desk: Press and hold the down button for 5 seconds, and the screen will show “RES”. Continue holding until the desk goes down to its lowest level and comes back up slightly USB Ports RATED...
- Página 8 Warnings Do not exceed desk Keep area of vertical weight limit. motion free of obstacles. Keep weight on desk Leave enough slack in balanced for correct cables to allow for full range operation and longer life of vertical motion. of components.