Publicidad
Reset
Press and hold the
Change Display
displayed. Press
Height Units
(metric), and press
Change Collision
Press and hold the
displayed. Press
Detection
switch between off, low, normal, and high sensitivity. Press
Sensitivity
Press and hold the
RESET
will show 'RES.' Continue holding until the desk goes down to its lowest level and comes
back up slightly.
Overheating Protection: When the motor has been working continuously for 2 minutes,
Hot
it will stop operating to prevent damage from overheating. Wait for at least 18 minutes before
making any further height adjustment.
Sensor Malfunction Warning: Motor safety sensor can't be detected. Power off, check the
El0
connection between the motor and controller, and power back on again.
Overloading Warning: Max load exceeded. If raising the desk, remove objects from the desk to
E20
reduce weight and try again. If lowering the desk, power off, take the things off the desk,
power back on, and try again.
Operation Status Warning: The desk stops moving if vibration, impact, or incline are detected.
E02
If this detection is incorrect, follow the reset instructions before continuing use.
Overvoltage Protection: Input voltage too high. If the correct AC adapter is being used, power
E32
off the desk, check the connection between power and the controller, and power on again.
Undervoltage Protection: Input voltage too low. If the correct AC adapter is being used, power
E31
off the desk, check the connection between power and the controller, and power on again.
Unequal Leg Height Warning: Power off the desk and check whether the left and right legs are
E60
at the same height. Power on again and adjust if necessary by following the "RESET" instructions.
Cable Disconnection Warning: Check motor and controller cable connections. Normal operation
-
should return once all connectors are properly connected.
Settings
button until a flashing 'S-' is displayed. Press
to select it, press
to save your choice.
button until a flashing 'S-' is displayed. Press
or
to switch to 'CF' and press
button for 5 seconds, and the screen
Protection Mode Error Codes
or
to switch between 'IN' (imperial) and 'SI'
to select it. Press
to save your choice.
again, and 'Un' is
again, and 'Un' is
or
to
3
Publicidad
