Publicidad
Idiomas disponibles
Idiomas disponibles
Once connected to 2.4ghz wifi and with bluetooth enabled, open
Energeeks 3.0 and follow the steps below:
•
Connect the plug to the shocket, then keep the reset button
on the plug pressed for approximately 5 seconds, until the led
indicator begins to flash rapidly.
•
In the application, press the "+" in the upper right corner and
select "add device".
•
The app will detect the plug automatically, so press the red
"add" button and follow the instructions of the app.
If the application does not detect the plug, it may be because the
device is not in installation mode (the led flashing rapidly), or
because bluetooth is not activated. Please fix it and try again or
continue with the EZ installation.
EZ Installation (Easy Mode)
Once connected to the 2.4ghz Wi-Fi, open Energeeks 3.0 and follow
the steps below:
•
In the application, press the "+" in the upper right corner and
select "add device".
•
Select Wifi Sensor and follow the instructions of the
application.
Connection failure: If the installation process fails, please make sure
the Wi-Fi network is 2.4Ghz and the password of your Wi-Fi network
is correct.
EZ Install may fail if your firewall settings are too restrictive, or if
the application has not been granted network browsing permissions
and/or access to nearby devices. In that case, install the device in
"Access Point" mode.
20
Publicidad
