Publicidad
Idiomas disponibles
Idiomas disponibles
2. Connecting the Ice Maker to the Power Supply
Danger: Improper use of the grounded plug can result in the risk of electrical shock. If
the power cord is damaged, please contact our customer service for service.
This appliance should be properly grounded for safety. The power cord of this appliance is
equipped with a three-prong plug that mates with standard three-prong wall outlets to
minimize the possibility of electric shock.
Plug the appliance into an exclusive, properly installed, and grounded wall outlet. Do not cut
or remove the third grounded prong from the power cord under any circumstances. Any
questions concerning the power and/or grounding should be directed toward a certified
electrician.
Please plug the appliance into a standard 220-240V and 50Hz electrical outlet with a
three-prong ground.
3. Use Descriptions
Open the cover, remove the ice basket and pour water into the tank.
Keep the water level below the max water line.
Press the ON/OFF button on the control panel to begin the ice-making cycle.
Select the ice cube size by pressing the SELECT button. If the room temperature is lower
than 15℃, it is recommended to select the small ice cube to avoid ice sticking together.
The ice-making cycle lasts approx. 6 to 13 minutes, depending on the selection of ice cube
size and the room temperature. The recommended room temperature is 10℃ to 43℃
If the water pump cannot inject water, the ice maker will stop automatically, and the ADD
WATER indicator will be on. Press the ON/OFF button, and fill water up to the max. water
line. Press the ON/OFF button again to turn on the appliance again. Allow the refrigerant
liquid inside the compressor at least 3 minutes to settle before restarting.
The ice maker stops when the ice basket is full and the ICE-FULL indicator will be on.
Warning: Direct sunlight or sunlight reflection may cause the infrared sensor malfunction. If the
appliance does not stop making ice when ice cubes obstruct the sensor, move the appliance to
other places where there is no sunlight.
Change water in the water tank every 24 hours to ensure reasonable hygiene. If the appliance
will not be used for a long time, drain all the water and dry out the tank.
Cleaning and Maintenance
Before using the ice maker, it is strongly recommended to clean it thoroughly.
1.
Take out the ice basket.
2.
Clean the interior parts with diluted detergent, warm water and a soft cloth.
3.
Rinse the interior parts with water, and drain out the water by unplugging the water drain cap
at the front bottom side.
4.
The outside of the ice maker should be cleaned regularly with a mild detergent solution and
warm water.
5.
Dry the interior and exterior parts with a clean soft cloth.
If the appliance will not be used for a long time, drain the water inside completely and dry it
6.
out.
5
Publicidad
