Publicidad
Idiomas disponibles
Idiomas disponibles
EN
PEAK — E — Figure 3/4
Adjusting — Figure 3
Loosen without removing the three screws (F) on the right, left and central part. Adjust the
position of the peak by rotating it upwards or downwards until the desired position is obtained.
After finding the position, tighten the three screws and re-check the position of the front part.
For all these operation, use the proper tool to tighten these screws.
FIGURE 3
Replacing — Figure 4
Loosen and remove the three screws (F) placed on the t right, left and central part. Position
the new peak by making the holes match with the three threaded fittings on the shell. Insert the
screws in the specific housings without tightening completely. Adjust the position of the peak
and lock it into position as indicated in above paragraph.
For all these operation, use the proper tool to tighten these screws.
F
F
FIGURE 4
20
F
E
F
F
F
F
PADDING — G — H — Figure 5
The inner padding can be easily removed to be washed or replaced.
FIGURE 5
Inner central padding: INNER SHELL — G — Figure 6
Assembly and disassembly
The inner shell (G) is fixed to the helmet through four press studs (I)
Removing
Snap to open the press studs (I) and remove the inner shell (G). Be very careful when removing
the shell, press on the rigid part of the stud and pull slightly towards the inside of the helmet
without damaging the press stud.
Caution: to avoid damages to the inner lining, before removing the inner shell make
sure that all the press studs have been unhooked.
Assembly
Insert the shell (G) inside the helmet checking the assembly direction. Fasten the press studs
(I). After fixing the inner shell, make sure the shell is correctly positioned inside the helmet
F
(polystyrene padding).
FIGURE 6
H
H
G
I
G
I
G
EN
I
I
21
Publicidad
