Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Push clutch
cable housing
guide into
bracket,
slide collar
onto guide and
secure
with large retainer
spring.
8.
Place flat washer
and clutch spring
on
idler pulley
bolt and secure
with small
retainer
spring.
9.
Make sure belt is inside
the belt keeper
at the idler and on both sides of the
wire belt keeper
as shown.
10. Install
belt onto engine
pulley.
IMPORTANT:
Check
belt for proper
rout-
ing in all mower
pulley grooves.
TO LEVEL
MOWER
HOUSING
Adjust
the mower while
tractor
is parked
on level ground
or driveway.
Make sure
tires are properly
inflated
(See "PROD-
UCT SPECIFICATIONS"
section
of this
manual).
If tires are over or underinflated,
you will not properly
adjust
your mower.
SIDE-TO-SIDE
ADJUSTMENT
• Raise mower
to its highest
position.
• At the midpoint
of both sides of mower,
measure
height
from bottom
edge of
mower
to ground.
Distance
"A" on both
sides of mower should
be the same or
within
1/4" of each other.
• If adjustment
is necessary,
make adjust-
ment on one side of mower only.
• To raise one side of mower,
tighten
lift
link adjustment
nut on that side.
• To lower one side of mower,
loosen
lift
link adjustment
nut on that side.
NOTE:
Each full turn of adjustment
nut
will change
mower
height about
1/8".
• Recheck
measurements
after adjusting.
Bottom edge of
Bottom edge of
mower to ground
mower to ground
Suspension Arm
To obtain
the best cutting
results,
the
mower
housing
should
be adjusted
so
that the front is approximately
1/8" to 1/2"
lower than the rear when
the mower
is in
its highest
position.
Check
adjustment
on right side of trac-
tor. Measure
distance
"D" directly
in front
and behind
the mandrel
at bottom
edge of
mower
housing
as shown.
• Before
making
any necessary
adjust-
ments,
check that both front links are
equal
in length.
• If links are not equal
in length,
adjust
one link to same
length
as other
link.
• To lower front of mower
loosen
nut "E"
on both front links an equal
number
of
turns.
• When
distance
"D" is 1/8" to 1/2"
lower at front than rear, tighten
nuts "F"
against
trunnion
on both front links.
• To raise front of mower,
loosen
nut "F"
from trunnion
on both front links. Tighten
nut "E" on both front links an equal num-
ber of turns. The two front links must
remain
equal in length.
• When
distance
"D" is 1/8" to 1/2" lower
at front than rear, tighten
nut "F" against
trunnion
on both front links.
• Recheck
side-to-side
adjustment.
o o
le
o o
_--__
Mandrel
Both Front Links Should be
ual in Length
Nut "F"
Trunnion
Lift Link Adjustment Nut
FRONT-TO-BACK
ADJUSTMENT
IMPORTANT:
Deck must be level side-to
side. If the following front-to-back
adjust-
ment is necessary, be sure to adjust both
front links equally so mower will stay level
side-to-side.
22
Front Links
Publicidad
