tibelec 77200110 Manual De Instrucciones página 9

1. INSTALLATION
a. Choice of location
Avoid exposure to high variations in temperature and direct sunlight. Never install close to a
water supply or sink! Do not install the detector close to air conditioning or heating systems.
Choose your location carefully so that nothing can hinder detection and so that the infrared
sensor works properly. Avoid obstacles – the detection field must be free.
b. Connecting
For built-in wall installation, the detector takes the place of a traditional single light switch.
It is powered by 2 wires – be sure to respect the colours:
230V = L: phase - brown. Device to connect = A: red.
• Connect the lamp to a Class II light fixture (not to be connected to earth).
• Shut off the power at your electrical board.
1
clic
9