Würth BS 12-A Instrucciones De Servicio Originales página 14

application tool becomes blocked when it becomes
jammed in the workpiece or when the power tool becomes
overloaded.
Use suitable detectors to determine if there are
r
hidden supply lines or contact the local utility
company for assistance. Contact with electric cables
can cause fire and electric shock. Damaging gas lines can
lead to explosion. Breaking water pipes causes property
damage.
Hold the power tool securely. When tightening and
r
loosening screws be prepared for temporarily high torque
reactions.
In case of damage and improper use of the bat-
r
tery, vapours may be emitted. The battery can
set alight or explode. Ensure the area is well ventil-
ated and seek medical attention should you experience
any adverse effects. The vapours may irritate the respirat-
ory system.
Do not open the battery. There is a risk of short-circuit-
r
ing.
The battery can be damaged by pointed objects
r
such as nails or screwdrivers or by force ap-
plied externally. An internal short circuit may occur,
causing the battery to burn, smoke, explode or overheat.
Only use the battery with products from the
r
manufacturer. This is the only way in which you can
protect the battery against dangerous overload.
Protect the battery against heat, e.g.
against continuous intense sunlight,
fire, dirt, water and moisture. There is a
risk of explosion and short-circuiting.
Use only original Würth accessories.
r
Product Description and
Specifications
Read all the safety and general instruc-
tions. Failure to observe the safety and general
instructions may result in electric shock, fire and/
or serious injury.
Please observe the illustrations at the beginning
of this operating manual.
Intended use
The power tool is intended for driving and loosening screws
and for drilling in wood, metal, ceramic and plastic.
Product features
The numbering of the product features refers to the diagram of
the power tool on the graphics page.
14
(1) Keyless chuck
(2) Torque presetting ring
(3) Gear selector switch
a)
(4) Battery release button
a)
(5) Battery
(6) Rotational direction switch
(7) On/off switch
(8) Battery charge indicator
(9) "PowerLight" lamp
(10) Handle (insulated gripping surface)
a)
(11) Universal bit holder
a)
(12) Screwdriver bit
a) Accessories shown or described are not included with
the product as standard.
Technical Data
Cordless Drill/Driver
Article number
Rated voltage
A)
No-load speed
– 1st gear
– 2nd gear
Max. torque, hard/soft screw-
driving application according
A)
to ISO 5393
Max. drilling diameter
– Steel
– Wood
Screw diameter max.
Chuck capacity
Weight according to EPTA-
B)
Procedure 01:2014
Recommended ambient tem-
perature during charging
Permitted ambient temperat-
C)
ure during operation and
during storage
Recommended rechargeable
batteries
Recommended chargers
A) Measured at 20−25 °C with rechargeable battery AKKU-
LI-12V/1,3 Ah
B) Depends on battery in use
C) Limited performance at temperatures <0 °C
Noise/vibration information
BS 12-A
5700 130 000
V= 12
-1
min 0–400
-1
min 0–1300
Nm 30/15
mm 10
mm 19
mm 7
mm 1.0–10
kg 1.0–1.2
°C 0 to +35
°C –20 to +50
AKKU-LI-
12V/x,x Ah
AL 40-LI