"AIR JUMPER" BOUNCER
IMPORTANT! KEEP THESE INSTRUCTIONS FOR FUTURE USE
PRECAUTIONS
The doorframe wall should be between 10 and 15 cm thick.
The top part of the doorframe should have a flat sill of at least 1,5 cm on each side.
Check that the doorframe is strong enough to support the baby in the bouncer.
Recommended from when the baby can hold their head upright (approximately 4 months) until they start walking
or 12 Kg.
Do not keep the baby in the bouncer for longer than 20 minutes at a time.
Never leave the baby alone in the bouncer.
Never place more than one baby in the bouncer.
Once the bouncer has been installed, check that the door cannot be closed.
This bouncer is not a toy.
Only use spare parts supplied by JANÉ, S.A.
The bouncer must be installed only by an adult.
WARNING
-NEVER LEAVE THE BABY ALONE OR UNACCOMPANIED.
-DO NOT USE THE BOUNCER AS A SWING.
-ENSURE THAT THE BOUNCER IS CENTRED IN THE TOP OF THE DOORFRAME.
COMPONENTS
See attached diagram
ASSEMBLING THE BOUNCER
Once the float has been inflated, insert the vertical support through the bottom
hole of the horizontal support.
IMPORTANT: (see attached drawing)
For correct assembly, ensure that the 2 side pivots or cylinders on the bottom
of the vertical support coincide with the 2 cylindrical openings in the bottom
part of the horizontal support.
TOP CLAMPS
HEIGHT
ADJUSTMENT
MECHANISM
INFLATABLE
SIDE
4
METAL ARMS
SAFETY LOCK
BELT
VERTICAL SUPPORT
HORIZONTAL SUPPORT