Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
D
7/16"Screws
Support
_,j_,
"_'
1:?::1: .....
ptatfor m
...... :::::
....... ::J.
f_@_)
_&¢
//
'_
............
Support angle
I
Leveling bolt
D
Two 1"long self-tapping screws
Support
platform
assembly
Lower window
track
Topretainer
Filer panel
Sliders
Shorter seal
Sliding
Windowlnstallation
1.Choose theinstatIation site. It is imperative that the window
frame assembly andthe side of the structure areadequate to
support the weightof the unit. Reinforce if necessary.
2.Slide openone window sashto install support platform.
3.Loosely attach support angle to bottom of supportplatform
using two 7/16"screws, washers andnuts. (See fig. A)
4.Place support platform against lower window track and
firmly against verticaledge of windowfrarne.
5.Attach support platform to windowsill using two 1"
self-tapping screws. Toovercome interference ofsupport the
Platform with windowtrack or stormwindow, securely attach
a2" wide shim stripto the windowsill. Thestrip should beas
long as the width of the support platform and flush withthe back
edge of the siIbThe thickness of the strip should be controlled
by the amountof interference.(See fig. B)
&Pull supportangIe against outsideof structure. Tighten two
7/16" screws on topof the supportpIatform.
7.Adjust leveling bottto position supportangle in alevel
plane. Thiswill allow forthe proper angle.Tighten leveling
bolt tocknut.
Important: Unit must be level ortilted back slightlyto
facilitate proper condensatedisposal.
Caution: Do notdrill a holein the bottompan. The unit
is designed tooperate with approximately 1/2" of
water in thebottom pan.
8.Cut two piecesof adhesive sealto height ofwindow
opening. Remove backingand apply tovertical inside
edges of windowframe and sliding sash that will rest
against unit.(See fig. C)
9.Slide unit ontosupport platform. Besure unit side
channel butts againstvertical edge ofwindow frame.
Note: If unitside channel doesnot fit securely,
remove unit and readjust leveling bolt.
10.Drill two 1/8" holes through windowchannel frame
in alignment with existing holes in bottom bar. Install
two 3/8" long self-tapping screwsthrough these holes.
If the windowchannel frame isnot tall enoughto use
existing holes, drill new holes off to theside of the
existing holes toattach the unitbottom bar tothe
support platform.The unitshould be firmlyanchored to the
window channel frameor support platform.(Seefig. D)
11.Slideinside window sash closed. Be surevertical edge
of inside windowsash is pressed firmly against sideof unit
cabinet. Cut remaining seal to width of window opening.
Remove backing andapply to topinside edge ofwindow
frame.(See fig. C)
The above installationsare
intended
tobe
permanent,
and when installed
in apartment
orrental
properties,
permission
to makethe
above modificationsshould
be
obtained
from ownersor
landlords
of buildings
prior
to installation
of unit.
Publicidad
