Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be returned
to your distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Vellight! Please read the manual thoroughly before bringing this device into
service. If the device was damaged in transit, don't install or use it and contact your dealer.
2.
Safety Instructions
Risk of electroshock when opening the cover. Touching live wires can cause life-
threatening electroshocks.
This luminaire does not have a built-in device to disconnect it from the electric mains.
Make sure to electrically isolate the luminaire before installation or maintenance
activities are performed.
Do not use when damage to housing or cables is noticed.
Never install on live electronic circuits. Make sure to cut the power first.
Do not use the luminaire with a cracked or broken protective shield. Disconnect
immediately from the mains.
3.
General Guidelines
Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.
4.
Overview
Refer to the illustrations on page 2 of this manual.
a
screw holes
b
power supply
c
terminals
5.
Installation
Refer to the illustrations on page 2 of this manual.
1.
Mount the base on the ceiling. First, open the lamp by rotating the dome in an anticlockwise
direction (fig. 1). Solidly fix the base onto a secure point of the ceiling using the included plugs and
self-tapping screws (fig. 2a).
2.
Connect the power cable. First, cut off the live circuit and make sure the ground wire is
connected. Next, connect the AC power lines (fig. 3d + 4d) to the neutral (N) and live (L) terminals
(fig. 3c + 4c + 5).
3.
Mount the lamp dome. Place the dome on the base and rotate in a clockwise direction until the
dome is locked.
V. 03 – 17/12/2015
LEDA37NW/LEDA38NW
USER MANUAL
Indoor use only. Keep away from rain, moisture, splashing and dripping liquids.
d
AC power line entry
e
LED source
3
©Velleman nv
Publicidad
