Publicidad
Idiomas disponibles
Idiomas disponibles
Protection from eye injury
This fixture corresponds to Risk Group 3 according to EN 62471 when all photobiological
risks are considered and Risk Group 2 according to IEC/TR 62778 for blue light only. It
emits possibly hazardous optical radiation. It falls into the Risk Group categories shown
below according to EN 62471 and IEC/TR 62778 under worst-case conditions:
At a distance of less than 3.5 m (11.5 ft.) from the fixture, the light output can potentially
cause eye or skin injury before an exposed person's natural aversion responses (blink reflex
and reaction to skin discomfort) can protect them. At distances greater than 3.5 m (11.5 ft.),
potential eye and skin injury hazards from the light output are normally prevented by natural
aversion reflexes.
Position the fixture so that persons cannot be exposed to the fixture's light output at a
distance of less than 3.5 m (11.5 ft.) from the fixture and so that prolonged staring into the
light output at less than 9 m (29.6 ft.) is not expected.
Do not look directly into the fixture's light output.
Do not look at the light output with magnifiers, telescopes, binoculars or similar optical
instruments that may concentrate the light output.
Ensure that persons are not looking directly into the front of the fixture when the product
lights up suddenly. This can happen when power is applied, when the product receives a
DMX signal, or when certain control menu items are selected.
Disconnect the fixture from power at all times when the fixture is not in use.
Provide well-lit conditions to reduce the pupil diameter of anyone working on or near the
fixture.
Protection from injury
The fixture weighs 39.7 kg (87.6 lbs.) not including rigging hardware.
When the fixture is in use, it must be either:
•
fastened to a secure, stable structure such as a rigging truss, or
•
standing on a stable horizontal surface where it will not present a danger of tripping or
falling.
Install the fixture only as directed in this manual.
The fixture is not portable when installed.
Ensure that any supporting structure and/or hardware used can hold at least six (6) times
the weight of all the devices they support.
Make sure that all supporting structures and rigging hardware items (including safety cables
and fasteners) are in perfect condition, safely dimensioned, suitable for the installation
environment and will be stable under all weather and temperature conditions.
If suspending from a rigging structure, fasten the fixture to a truss or similar support using
two rigging clamps and omega brackets. Do not use safety cables as the primary means of
support.
If the fixture is installed in a location where it may cause injury or damage if it falls, install as
directed in this manual a secondary attachment such as a safety cable that will hold the
fixture if a primary attachment fails. The secondary attachment must be approved by an
official body such as TÜV as a safety attachment for the weight that it secures, must comply
®
Martin
ERA 700 Performance IP Safety and Installation Manual Rev. C
7
Publicidad
