Danby Designer DCR432W Manual Del Propietário página 3

ATTENTION
GROUNDING INSTRUCTIONS
This app/tance must be grounded. In
the event of an electrical short circuit,
grounding reduces the risk of eleetrtcaI
shock by providing an escape wire for the
electrical current.. This appliance is
equipped with a cord having a grounding
wire with a grounding plug. The plug must
be plugged Into an outlet that is properly
Installed and grounded.
WARNING - Improper use of the
grounding plug can result in a riskof electdc
shock, Consull a qualified electrician or
serviceman if the grounding instructions are
not completely understood, cr iFthe doubt
exists as to whether the appliance is
properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet, Do not connec!
your refrigerator !o extension cords or
together with any other appliance in the
same wall oullel. Do not splice the cord_
IMPORTANT WARNING
An empty refrigerator is a very dangerous
atlraciion to chi!dren. Remove either the
gasket, latches, lids or doors from unused
appliances, or take some other action that
will guarantee It harmless.
DANGER: R Jsk of childen|rapmentBeam youthrow_way
youroldre:tdge_alor or freezer:
,.T_ke off t he doers
* Leaveihe ehe_vee t npl_eeso _h_t _ hlldrenmay
nat essi[yclimb inside.
DON'T WAiT DO iT NOW!
--- __i] ,.....
Remove the exterior and interior packings, wipe
the outside thoroughly with a soft dry cloth and
the Ins/de with a wet, lukewarm cloth. Avoid
placing the cabinet in a narrow recess or near
any heat source, direct sunlight, or moletureo
Let air circulate freely around the cabinet. Keep
the rear of the refrigerator 5 inches away from
the walL
Location
1. Select a place with a strong, level floor,
2. Allow 5 Inches of space between the back of
the refrigerator and any adjacent wallo
3. Avoid direct suntight and heal Direct
sunlight may alfect the acryiic coating°
Heat sources nearby wit! cause higher
elechlci[y consumption.
4, Avoid very moist places. Too much moisture
in the air will cause frost to form very quickly
on the evaporator, and your refrigerator will
have to be defrosled very frequently
To avoid vibration, the cabinet must be set level.
To slarl the refrigerator, turn lhe temperature
control to the position corresponding to (he
desired cooling The refrigerator temperature
witl vary depending on the quantlly of the food
stored and on the frequency with which the door
is opened.
Turn the control to the "OFF" position to
temporarily disconnect: the cobl_ngcycle. Alter
defrosting and if the refrigerator has been left out
of use for some time, set the control to maximum
for 2 to ;3hours before turning to the desired
posit_on When the refrigerator _snot to be used
for a long pedod of time, disconnect the plug and
leave the deer partially open,
Note: Wait 3 to 5 minutes before restarting If
operation has been interrupted
ice Cube Tray
FIg. C
Ice cube tray is flexible. Twist tray to remove
f'cecubes, if the Ice cube tray is frozen hard to
the evaporator surface, run a It|tie water over the
lray_ Never use a knife or other metal instrument
to remove ice cube tray because this may
damage the evaporator. (Fig. C)