Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: The side t he unit t urns t oward
indicates
that the wheel on that s ide i sturning
slower than t he other wheel. Either the wheel
that i sturning faster needs toslow down o r
the wheel that i sturning slower needs tobe
sped u ptoallow the unit t otravel inastraight
line.
1.Determine
which w ay t he unit turns.
NOTE: The forward travel adjustment
bolt
adjusts the rear t ravel ofthe steering lever.
The rear travel adjustment
bolt a djusts the
forward travel ofthe steering lever.
2.Adjust speed b y loosing jam nut a nd:
Turning adjustment
bolt c lockwise
to
decrease
steering lever travel.
Turning adjustment
bolt c ounter
clockwise
toincrease
steering lever
travel.
1. Forward
Travel Adjustment
Bolt
2. Rear Travel Adjustment
Bolt
3. Steering
Lever
Figure 20
REPLACING PTO BELT
Remove
(Figure
21)
1. Lower mower deck to the ground.
2. Remove belt covers from mower deck.
CAUTION:
Use care when
releasing idler spring tension.
Keep body parts well away from
idler when performing this
operation.
3. Hook a puller into idler hole and pull idler
arm towards outside of unit until tension
is removed from PTO belt.
3
4
2
1
1. Idler Spring
2.
Electric Clutch
3. PTO Belt
4.
Idler Hole
5. Idler Pulley
6.
Idler Arm
7. Belt Cover
Figure 21
4. Remove PTO belt from left mower deck
pulley.
5. Slowly release idler arm until tension is
removed from idler spring.
6. Remove PTO belt from mower deck and
electric clutch.
Install
(Figure
21)
NOTE: Do not install PTO belt on left mower
deck pulley in step 1.
1. Install PTO belt on electric clutch and
mower deck.
2. Hook a puller into idler hole and pull idler
arm towards outside of unit until PTO
belt can be routed around left mower
deck pulley.
3. Slowly release idler arm until idler pulley
rests firmly against PTO belt.
4. Install belt covers on mower deck.
REPLACING HYDROSTATIC BELT
Remove
(Figure
22)
1. Remove PTO belt (see REPLACING
PTO BELT on page 22).
2. Disconnect electric clutch connector.
3. Remove clutch stop.
A
AUTION: Use care when
releasing idler spring tension.
Keep body parts well away from
idler when performing this
operation.
GB - 22
Publicidad
