Ariens 2042 Zoom XL Manual Del Propietario - Operador página 23

4.Disconnect idler spring.
5.Remove hydrostatic belt f rom
hydrostatic transmission pulleys, pulley,
electric clutch, and idler.
Install ( Figure 22)
1.Install hydrostatic belt o nidler, electric
clutch, pulley, and hydrostatic
transmission pulleys.
2.Connect idler spring.
3.Install clutch stop.
4.Connect electric clutch connector.
5.Install PTO belt ( see
R EPLACING PTO
BELTon page 22)
2
1. Hydrostatic Belt
2. Hydrostatic Transmission Pulley
3. Pulley
4. Electric Clutch
5. Idler
6. Idler Spring
Figure 22
Check Hydraulic Fluid Level
Check the system with the unit cold and
parked on a flat, level surface.
Then run the unit for about one minute and
recheck the levels.
To Add Hydraulic Fluid:
1. Remove the cap from the expansion
tank.
2. Fill the expansion tank with 20W-50
engine oil with an SL API classification
until oil level reaches the cold fill line on
the tank.
3. Install the expansion tank cap and then
purge the system. See "Purging the
Hydraulic System" on page 24.
The hydraulic fluid should be at the cold
fill line of the expansion tank.
Figure 23
Change Hydraulic Fluid and Filter
NOTE: Change hydraulic fluid and filter after
the first 75 hours of operation and then every
400 hours. Use 20W-50 engine oil with an SL
API classification.
1. Place container under oil filter to catch
oil.
2. Remove the filter guard and oil filter from
the transaxle.
3. Remove the oil drain plug or fitting from
the inlet port and allow the transaxle to
drain completely.
4. Clean the filter mounting surface and
then lubricate rubber gasket on new oil
filter with clean hydraulic oil.
5. Spin new oil filter onto filter housing until
it makes contact. Tighten oil filter
another 3/4 turn.
6. Install the filter guards removed in
step 2. Tighten the mounting screws to
65 Ibf-in (7.3 N°m).
7. Fill with 20W-50 engine oil with an SL
API classification until oil appears at the
bottom of the drain plug (about 2 quarts
per transaxle). Install the drain plug and
tighten it to 180 Ibf-in (20.3 N°m).
8. Repeat steps 1-7 for the other
transaxle.
9. Follow the instructions in "To Add
Hydraulic Fluid:" on page 23.
GB - 23