Publicidad
Idiomas disponibles
Idiomas disponibles
How to Set the Door Alarm_
You don't have to set the visual
alarm. As long as either door is
open, the red DOOR OPEN
signal light flashes
DOOR OPEN
If the signal light on the
DOOR ALARM
pad
is glowing,
_a DOOR_M
the beeper alarm
is set. If it's not,
B
ON/OFF
touch the pad to turn it on
k
If either door is open for more than
30 seconds, a recurring beep sounds
The light goes out and the beeping stops when you close
the door,
There are times when you'll want the Door Alarm
beeper
turned
off, When you're rearranging
a lot of
food, for example° Just touch the pad The light will go
out and the beeping will stop_
Deactivating the Door Alarm beeper does not turn the
red DOOR OPEN light off-it keeps flashing until the
door is closed.
Why the Red Warm
Temperature
Light Glows°
At first, it's probably
because
your newly installed refrigerator
hasn't completely cooled down
yet. Wait a few hours for it to coot,
and then the light will go ouL
WARM TEMP
From then on, the red light will glow whenever
temperatures inside get too high for proper food storage.
if this happens, open the doors only when absolutely
necessary, and close them as quickly as possible.
As soon as inside temperatures return to normal, the light
goes out°
If the WARM TEMP light reappears and stays on br
longer than 4 hours, call for service.
How the Electronic Alert
and Diagnostic
System Works_
The word NORMAL
is lighted
except when a failure has
been detected.
NORMAL
The SYSTEM CH ECK_RESET
pad has two functions:
1 .You can touch the SYSTEM
CHECK-RESET pad and get a
review of the electronic diagnostic
codes in order of their priority.
/ cHEcK /1
k_.222_Jf
2,You can touch the SYSTEM CHECK-RESET pad to
erase three flashing codes immediately and two codes
afier the condition that caused them to flash has been
corrected (see the next page}
(continued next page)
Publicidad
