Publicidad
Idiomas disponibles
Idiomas disponibles
Method of Connecting Extended Pipe
Detach the joint of the hot exhaust pipe and
cover the extended pipe outside the hot exhaust
pipe. Screw the end tight and cling to it.
Use adhesive tape to fixate it if necessary. Use
binder to fixate the attached pipe opening of
the extended hot exhaust pipe.
7
OPERATION METHOD
Operation Method and Blast Capacity Choosing
Rotate the selecting switch on the cover of the machine to
launches refrigeration. In the meantime, start the draught fan to blow air out. The blast capacity has
or
for customer to choose from.
When the switch is rotated to "0", the machine is off and stops running.
Attention: Please turn the selecting switch off and cut the power off before moving the machine.
When the machine is off, it may be restarted after 3 minutes.
Compressor Overheat and Overload Protection
Overly high or low voltage and overly high environment temperature may cause the compressor to
overhead and overload. To protect the compressor, the overload protector will be activated to cut the
power of the compressor off.
Attention: When the overload protector is activated, the machine only blows out natural wind but
does not refrigerate. If the overload protector is activated frequently, please find out and eliminate the
cause before using the machine.
Range and Operation of Adjustment of Air-out Direction
Cold air pipe may rotate left or right to 360 degrees (hot air pipe is
installed). Cold air pipe may be moved up or town to 150 degrees.
The range of adjustment angle for hot air pipe is 45 degrees.
Attention: Please adjust the cold exhaust pipe in advance and use
the air-out direction of the hot exhaust pipe later. When adjusting the
air-out angle of cold exhaust pipe, please grip the elbow for adjustment
and do not hold the cold exhaust pipe directly.
or
and the compressor immediately
9
EN
Publicidad
