Publicidad
Idiomas disponibles
Idiomas disponibles
• Warn the operator of the danger of blade thrust.
• Blade thrust may occur when the spinning blade
contacts an object that it does not immediately cut.
• A blade thrust can be violent enough to cause the
unit and/or operator to be propelled in any direction,
and possibly lose control of the unit.
• Blade thrust can occur without warning if the blade
snags, stalls or binds.
• Blade thrust is more likely to occur in areas where it
is difficult to see the material being cut.
The handles and shield must be mounted according to the
instructions. Do not attach any blade to a unit without proper
installation of all required parts. Failure to use the proper parts
can cause the blade to fly off and seriously injure the operator
and/or bystanders. Discard blades that are bent, warped,
cracked, broken or damaged in any way. Use a sharp blade. A
dull blade is more likely to snag and thrust.
The cutting attachment may be spinning during carburetor
adjustments. Wear your protective equipment and observe all
safety instructions. Be sure the cutting attachment stops
turning when the engine idles. When the unit is turned off
make sure the cutting attachment has stopped before the unit
is set down. A coasting blade can cause injury while it
continues to spin after the engine is stopped when throttle
trigger is released. Maintain proper control until the blade has
completely stopped rotating.
6
A
WARNING: IT IS UNSAFE TO USE ANY AFTER MARKET HEAD,
ATTACHMENT, ACCESSORY OR BLADE ON THIS UNIT. USE
ONLY HEADS, ATTACHMENTS, BLADES AND ACCESSORIES
MANUFACTURED BY SNAPPER AND INTENDED FOR THIS
SPECIFIC MODEL.
TOOL LIST
Screwdriver (Phillips or Standard)
Allen wrench 4mm
10mm wrench
17mm wrench
INSTALLING THE "J" HANDLE
Install the clamp assembly on
the shaft tube. The top of the
clamp should touch the arrow on
the tube. Leave the screws and
nuts slightly loose.
Place J handle in clamp as
shown- The J shape goes on
right side of unit. Position the
handle until the arrow on the
handle touches the edge of
the clamp.
Tighten the screws.
THROTTLE-KILL SWITCH
To accelerate unit hold down
lever (3) with the palm of the
RIGHT hand. Then squeeze the
trigger (2).
To return to idle. Release
trigger (2).
To stop the unit push switch (1)
forward.
To start the unit pull switch (1)
back.
SHOULDER HARNESS
Place the strap over your left
shoulder and attach clip to
clamp eye on shaft tube.
Loosen clamp screw and slide
clamp up or down until unit
balances with head just touching
the ground.
Tighten screw.
Notice quick release feature.
INSTALLING CUTTING HEAD
See Service/Adjustments
Section for blade removal
instructions.
Make sure debris shield with line
cut off is properly installed. See
Shield Assembly Section.
Lock gear box (3) by inserting a
1/8 in. (4 mm) alien wrench or
pin thru hole and finding
corresponding notch.
Install splined washer (2) flat
side out.
To install head (1), turn
counterclockwise. Hand-tighten
head securely.
To remove head, turn clockwise.
GB
3
Publicidad
