GB
KEY FEATURES:
• 1200W Airstyler
• 2 heat/speed settings including cool air
• 3m Swivel cord
• Brush lock/release button
•38mm Big Brush attachment for a quick, easy, big &
bouncy blow-out.
• 32mm - 15cm Air Wand attachment for bouncy,
weightless curls.
• UK/EU plug adaptor for travel
TO FIT OR REMOVE ATTACHMENTS :
Ensure the airstyler is turned off and the attachment is
cool before removing.
To remove, press and hold the brush lock / release button
and twist the attachment clockwise about 5mm until the
attachment detaches from the airstyler handle.
To attach, align the "-" symbol on the handle with the lock
symbol on the attachment and twist it about 5mm anti-
clockwise until the symbols are aligned and the brush lock
/ release button clicks into place.
USE:
The Air Styler can be used on dry hair but it best on clean,
slightly damp hair.
Use as you would a normal hairbrush, brushing or curling
for a few seconds at a time. To freeze the style into place,
apply the cool setting before unrolling the brush from the
hair.
Use styling sprays in use or a setting spray to fix the final
style.
CLEANING AND MAINTENANCE :
Make sure the unit is cool, switched off and unplugged.
Housing may be wiped with dry, lint-free cloth. Special
attention must be taken to removed hair and dust from the
air intake.
Attachments can be cleaned with a damp cloth and
should be allowed to dry overnight before using again.
IMPORTANT INSTRUCTIONS:
SAFETY CAUTIONS
WARNING – FOR ADDITIONAL PROTECTION THE
INSTALLATION OF A RESIDUAL CURRENT DEVICE (RCD)
WITH A RATED RESIDUAL OPERATING CURRENT NOT
EXCEEDING 30mA IS ADVISABLE. ASK AN ELECTRICIAN
FOR ADVICE.
WARNING – THIS APPLIANCE MUST NOT BE TAKEN
INTO A BATHROOM, IT SHOULD NOT BE USED NEAR
BATHTUBS, SHOWERS, BASINS OR OTHER VESSELS
CONTAINING WATER OR OTHER LIQUIDS.
This product is not suitable for use in bath or shower.
THE STYLER SHOULD BE UNPLUGGED FROM MAINS
SUPPLY WHEN NOT IN USE.
Do not leave the styler unattended when switched on.
Allow the styler to cool down before storage.
Do not immerse in water or other liquids.
Do not place styler on soft material e.g. carpet, bedding,
towels, rugs etc.
Always ensure the voltage to be used corresponds to the
voltage stated on the unit.
Keep this product out of reach of children. The use of this
appliance by persons with reduced physical,
sensory or mental capabilities or lack of
experience and knowledge can give cause to
hazards. Persons responsible for their safety
should give explicit instructions or supervise
the use of the appliance.
Do not use any attachments with this styler, other than
those supplied by Diva Professional Styling.
Avoid allowing any part of the hot plates to contact the
face, neck or scalp.
Do not wrap the cord around the unit. Check cord regularly
for any sign of damage.
Damaged cords can be dangerous. If the supply cord of
this unit becomes damaged, discontinue use immediately
and return the appliance to your nearest authorised
service dealer for repair or replacement in order to avoid
a hazard. Special tools are required for any examination,
adjustment or repair. Unqualified repair work could lead to
hazardous conditions for the user.
We do not accept responsibility for damage to the product,
persons or other items(s), caused by misuse, abuse or
non-compliance with these instructions.
DE
PRODUKTMERKMALE:
• 1200W Luftgestalter
• 2 Wärme-/Geschwindigkeitseinstellungen einschließlich
Kühlluft
• 3m Drehkabel
• Bürstenarretierung/Freigabetaste
• 38mm Big Brush-Aufsatz für eine schnelle, einfache,
große & Hüpfender Ausbruch.
• 32mm - 15cm Air Wand-Befestigung für hüpfende,
schwerelose Locken.
• UK/EU-Steckeradapter für Reisen
ZUBEHÖRTEILE AUFSETZEN UND ABNEHMEN:
Schalten Sie das Gerät ab und lassen Sie das Zubehörteil
zunächst etwas abkühlen, bevor Sie es entfernen.
Um ein Zubehörteil abzunehmen, halten Sie die
Verriegelungs- / Entriegelungstaste gedrückt und drehen
Sie den Bürstenaufsatz etwa 5 mm im Uhrzeigersinn, bis
er sich von dem Griff löst.
Um ein Zubehörteil aufzustecken, setzen Sie es so an
das Gerät an, dass das „-"-Symbol am Griff dem auf dem
Aufsatz befindlichen Verriegelungssymbol gegenüber
liegt. Drehen Sie dann den Bürstenaufsatz etwa 5 mm