Step 6
Insert two METAL PINS (1R) into the BACK (E).
å
Fasten the SHELVES (D) to the BACK (E). Tighten two
å
HIDDEN CAMS.
NOTE: Be sure the METAL PINS (1R) in the BACK (E)
å
insert into the holes in the SHELVES (D).
Insert two METAL PINS (1R) into the other end of
å
the SHELVES (D).
Fasten the SHELVES (D) to the DIVIDERS (F). Use four
å
BLACK 1-7/8" FLAT HEAD SCREWS (2S).
Finished edge
F
Page 10
D
Surface with
HIDDEN CAMS
1R
Maximum
210 degrees
Minimum
190 degrees
1R
BLACK 1-7/8" FLAT HEAD SCREW
D
Surface with
HIDDEN CAMS
E
417932
Arrow
2S
(4 used in this step)
Finished edge
www.sauder.com/services
F