Publicidad
Idiomas disponibles
Idiomas disponibles
1.
Prog 1－4：these button for user to running and programming.
SC/CH ： Used to change sound control and auto running. The led light up means it is in sound
2.
control.
Prog<> ： Programming button or used to change the running direction.
3.
4.
Full ON：push and hold the all output will be full.
5.
Black Out：push it all output will be 00 and the corresponding led will flash. Push again all out
put go back.
6.
Chase1－4：4 chases, you can select one of them in running mode. Which one is running its
corresponding led will light up.
7.
Fade silder：the slider control the fade time of output from 0s－10s.
8.
Speed slider: used to control the running speed from 005s to 5 minutes for one step.
9.
Tap Sync：the running speed is controlled by button. The speed will be the interval of two times
push on.
10. Master button：instead of the master slider on the max..
11. Master slider：used to control all output.
12. Channel and flash button: push flash button the corresponding channel will be full. Channel
slider can control also.
13. Battery case：the battery type is 6F22. If the unit has not DCPOWER it will use the battery and
work on about 3 hours.
14. Audio input: 100MV -1V PP audio signal，3/4" phone jack.
15. DMX output: 3PIN XRL female.
16. DMX polarity change switch.
17. Power switch.
18. DC power input.
Publicidad
