Descargar Imprimir esta página

Deltafox DG-CGS 3615 Traduccion Del Manual De Instrucciones Originale página 76

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 125
GB
battery / power tool / device.
This ensures that the battery
and charger are not damaged.
Keep the charger clean and
away from wet and rain. Do
not use the charger out-
doors. Dirt and the entry of
water increase the risk of elec-
tric shock.
Operate the charger only
with the appropriate original
batteries. Charging other bat-
teries may result in injuries and
risk of fire.
Avoid mechanical damage to
the charger. This can result in
internal short circuits.
Do not operate the charger on
a combustible surface (e.g.
paper, textiles). Risk of fire due
to heating during charging.
If the power cable for this
equipment is damaged, it
must be replaced by the
manufacturer, a customer
service agent of the same or
a similarly qualified person
in order to prevent hazards.
Do not use the charger to
charge non-rechargeable bat-
teries.
Charging process
Do not expose the battery to
extreme conditions such as heat
and impact. There is a risk of
injury from leaking electrolyte
solution! In case of contact,
rinse with water or neutraliser
and consult a doctor if contact
has occurred with eyes etc.
76
Ensure that the equipment is
charged for no longer than
3-5 hours without interruption.
The battery and equipment could
be damaged and they consume
energy unnecessarily in case of
longer charging time. Overcharg-
ing invalidates the guarantee.
Charge the battery only in dry
areas.
Do not switch on the device
while charging it.
There is a risk of injury from
electric shock.
1.
The safety key (8) must be du-
ring the loading process plug.
2. Connect the charger cable plug
(18) with the charger socket on
the tool (7).
3. Connect the power supply unit
(17) to a socket.
The charging indicator (3) lights
up:
Red: Equipment charging.
Green: Charging finished.
The recommended charging
time is max. 3 – 5 hours.
4. After the recharging process
is completed, first unplug the
charger from the wall outlet, and
then remove the charger cable
plug (18) from the tool.
Operation
Keep to noise abatement regula-
tions and other by-laws.

Publicidad

loading

Este manual también es adecuado para:

Dg-cgs 3615 set