Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Connection
■ Terminal names
! Fuse (25 A × 3)
@ Battery terminal
# Ground terminal
% Speaker output terminals
As this unit accepts speakers with a
minimum impedance of 1 ohm, connect
speakers with 1-ohm or higher impedance
to these terminals.
2CAUTION
The rated input of the speakers should be
no less than the maximum output of the
amplifier. Otherwise malfunction may
result.
^ RCA cable ground lead terminal
When using an RCA cable with a ground
lead attached, connect the ground lead to
this terminal.
& LINE IN terminal
* LINE OUT terminal
The signal that's input from the line input
terminal is output.
POWER IN
SPEAKER
BATT.
P.CON
OUTPUT
!
@ # $
B.M.S.
BAND REJECT
PHASE
INFRASONIC
–6dB
OFF
REVERSE
OFF
ON
15Hz
NORMAL
REMOTE
+12dB
OFF
–12dB
GND
^
%
LINE IN
LINE OUT
EXT.AMP.CONT.
25Hz
L
L
R
R
& *
(
$ Power control terminal
Controls the unit ON/OFF.
NOTE
Controls the unit power. Be sure to connect it
with all the systems.
( EXT.AMP.CONT. (external
amplifier control) terminal
Controls the B.M.S. Only Kenwood center
unit models sold in 1999 or later with a
"EXT.CONT."/"EXT.AMP.CONT." wire
attached can be used.
Also, a maximum of 3 power amplifiers can
be operated at the same time.
NOTE
There are cases when operation may not be
possible due to wiring wire type and length.
7
English
Publicidad
Tabla de contenido
