Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY
To install the handle:
Push and hold the push-pin buttons on the frame as you
slide the handle onto the frame and over the buttons.
Adjust the handle so that the frame push-pin buttons
snap into holes in the base of the handle.
NOTE: Before use, pull the handle up until the push-pin
buttons snap through the locking holes to secure the
handle in place.
INSTALLING TRIGGER HANDLE HOLDER
See Figure 4.
Insert trigger handle holder into hole in handle, as shown.
Thread screw through holder and into handle. Tighten
securely.
AT TA C H I N G H O O K - A N D - L O O P H O S E
STORAGE STRAP
See Figure 5.
Locate the slot in the top of the nozzle storage panel.
Slide hook and loop strap into slot and buckle.
Neatly coil the high pressure hose and store with hook
and loop strap.
CONNECTING THE SPRAY WAND TO THE
TRIGGER HANDLE
See Figure 6.
Place the threaded end of the spray wand in the connec-
tor on the end of the trigger handle.
Turn the connector clockwise until it stops. This secures
the wand in place.
ATTACHING THE AUXILIARY HANDLE
See Figure 6.
Place the threaded stud on the end of the auxiliary handle
into the hole in the trigger handle as shown. Turn clock-
wise to tighten.
NOTE: You can install the handle on either the left or right
side of the spray wand, depending on operator prefer-
ence.
To switch sides, loosen the auxiliary handle and rotate to
the opposite side. Tighten securely before use.
CONNECTING HIGH PRESSURE HOSE TO
TRIGGER HANDLE
See Figure 7.
Pull back and hold the collar on the high pressure hose.
Insert the inlet coupler on the trigger handle into the collar.
Release the collar and push until it locks into place. Pull
on the hose to be certain it is properly secured.
CONNECTING THE HIGH PRESSURE HOSE TO
THE PUMP
See Figure 8.
Completely uncoil and straighten the high pressure hose
to prevent kinks.
NOTE: See Using The High Pressure Hose in Operation
for more information about using the high pressure hose.
Pull back and hold the collar on the pump outlet. Insert
the inlet coupler on the high pressure hose into the collar.
Release the collar and push until it locks into place. Pull
on the hose to be certain it is properly secured.
CONNECTING THE GARDEN HOSE TO THE
PRESSURE WASHER
See Figure 9.
NOTICE:
Always observe all local regulations when con-
necting hoses to the water main. Some areas have
restrictions against connecting directly to public
drinking water supply to prevent the feedback of
chemicals into the drinking water supply. Direct
connection through a receiver tank or backflow
preventer is usually permitted.
The water supply must come from a water main. NEVER use
hot water or water from pools, lakes, etc. Before connecting
the garden hose to the pressure washer:
Run water through the hose for 30 seconds to clean any
debris from the hose.
Inspect the screen in the water intake.
If the screen is damaged, do not use the machine until
the screen has been replaced.
If the screen is dirty, clean it before connecting the garden
hose to the machine.
9 - English
Publicidad
