Publicidad
Idiomas disponibles
Idiomas disponibles
CONNECTING THE USB CABLE
1. To encode music from your records or from the Line in line, connect the USB Port of
the Turntable to a suitable USB port on your computer via the USB cable provided.
2. Please refer to CONNECTING TO A COMPUTER FOR RECORDING section of this
manual for detail.
Please Note - Before Use
Remove the stylus protector.
-
Be sure that the tone arm is unlocked and free to
-
move from the tone arm rest prior to operating.
Lock the tone arm in place again when not in use.
1. Lift the BUCKLE on the front of the turntable and open the lid
2. Rotate the POWER/VOLUME knob clockwise until you hear a "click" sound to turn the
device on. The Power LED indicator will light up.
3. Put a record on the turntable platter. Remember to use the 45 RPM adaptor located
on the top-right corner when playing a 45 RPM record.
4. Remove the white plastic needle cover. Keep the needle cover in a safe and
accessible place
for future use.
4.
Select the speed according to the record you are playing.
5. Release the tone arm by unlocking the tone arm lock.
6. Lift the tone arm by pushing back the lift lever.
7. Gently move the tone arm towards the turntable. Then, push the lift lever forward. The
tone arm will gently descend onto the record and start playback.
8. To pause or stop playing, you need to manually lift and move the tone arm back to the
tone
NOTES:
Certain types of records may have an auto-stop area outside the preset limit, so the
turntable may stop before the last track finishes. If this occurs, set the AUTO-STOP
SWITCH (#9) to the "OFF" position. This allows the record to play to the end, but please
note that it will not stop automatically. You must manually raise the tone arm and place it
back in the rest and then turn off the power to stop the turntable from spinning.
An external device with Bluetooth Connectivity can be wirelessly connected to this
apparatus using the Bluetooth function.
1. Power on the unit by turning the VOLUME CONTROL KNOB clockwise. The red Led
will light to show that the turntable is turned on.
2. Turn the FUNCTION KNOB to the BT(Bluetooth) position, the blue LED light will begin
to flash
3. Turn your external device‟s Bluetooth Setting ON. Wait a moment, and then look for
the Bluetooth pairing name "TURN-10 ".
PHONO OPERATION
BLUETOOTH OPERATION
6
Publicidad
