Adeo Group PR/SFTR Instrucciones De Instalación página 3

Step 3:
Fix the spacer G to the radiator with bolts H.
[G]
x4
[H]
x4
Step 4:
Mount the radiator to the wall and tighten the Small Screws F in the brackets.
[F]
x4
3
After installation ...
● Use a screwdriver to open the air vent, open the valve and let the water rush into the towel warmer.
Check all connections for leaks.
● Once water overflows from the air vent, there is no air in the tube.
● Use a screwdriver to close the air vent, turn on the valve and the towel warmer is ready for use.
After care ...
● Classic towel warmers are made from steel with chrome plating, and should not be cleaned with
corrosive or scouring cleaning agents.
Please note ...
● This product can only be used at PN≤0.6MPa (6 Bar), It should only be filled with
water, and at a temperature below 100 °C (212°F) . See table below for installation
requirements.
● If the temperature exceeds 48 °C (oder 120°F), please show a warning sign near the product
to avoid burning and scolding accidents.
Fill 3/4 Full Pressure Temperature
Water only PN ≤0.6Mpa 0°C <t ≤100°C
ENGLISH
Comments
If ambient temperature drops below1°C,
drain out the water to prevent freezing
4