Publicidad
Idiomas disponibles
Idiomas disponibles
REFRIGERATOR FEATURES
Your model may
have some or allof these features.
important information to know about glass shelves
an(]
covers:
Do not clean glass shelves or covers with warm water when
they are cold. Shelves and covers may break if exposed to
sudden temperature
changes or impact, such as bumping.
Tempered
glass is designed to shatter into many small,
pebble-size
pieces. This is normal. Glass shelves and covers
are heavy. Use both hands when removing them to avoid
dropping.
Fold Away Shelf (on some models)
To remove and replace a shelf=
1. To remove the entire shelf, tilt up the front of the shelf and
slide it out toward you.
2. To remove the front-half
of the shelf, hold the front of the
shelf with one hand and press up in the center of the shelf.
Then push down and in on the shelf until it slides beneath the
back half of the shelf.
Rely'
She yes
Oass
sB® yes on sore® modes
The shelves in your refrigerator
are adjustable
to match your
individual
storage needs.
Storing similar food items together in your refrigerator
and
adjusting the shelves to fit different
heights of items will make it
easier to find the exact item you want. It will also reduce the
amount of time the refrigerator
door is open, and save energy.
Shelves and Glass Shelves (on some models)
To remove and replace a shelf=
I.
Remove items from the shelf.
2. Slide the shelf straight out to the stop.
3. Depending on your model, lift back or front of the shelf past
the stop. Slide shelf out the rest of the way.
4. Replace the shelf by sliding the back of the shelf into the
track in the wall of the cabinet.
5. Guide the front of the shelf into the shelf track. Be sure to
slide the shelf in all the way.
3. Replace the entire shelf by guiding it into the door liner and
pushing it inward until it stops. Then, tilt the front of the shelf
upward until the stopper is overcome and slide it in.
(o;"_s<:,m®models)
To remove and replace the meat drawer=
1. Slide meat drawer out to the stop.
2. Lift front of meat drawer with one hand while supporting
bottom of drawer with other hand. Slide drawer out the rest
of the way.
3. Replace the drawer
by sliding it back in fully past the
drawer stop.
Meat Drawer
Cover (on some models)
To remove and replace the meat drawer cover=
1. Remove the meat drawer.
2. Push the cover back to release the rear clips from the shelf.
Tilt the cover up at the front, and pull it forward.
3. Replace the meat drawer cover by fitting the notches and
clips on the cover over the rear and center crossbars on the
shelf.
4. Lower cover into place and pull the cover forward
to secure
the rear clips onto the shelf.
5. Replace the meat drawer.
NOTE: In some models the meat pan moves sideways on the
shelf to allow for flexible positioning.
16
Publicidad
