Injecta GEA R MT Manual De Instalación página 3

Access to the programming menu
When pressed during the pump operation phase, it cyclically displays the programmed values on the
display; When pressed at the same time
dependent on the selected operating mode. During programming it carries out an "enter" function,
meaning that it confirms entry to the various menu levels and modifications within the same.
Starts and stops the pump. In the event of a level alarm (alarm function only), flow alarm and active
memory alarm, it deactivates the signal on the display.
Used to "exit" the various menu levels. Before definitively exiting the programming phase, you will be
asked if you wish to save any changes
Used to run upwards through the menu or increase the numerical values to be changed. Can be used
to start dosage in Batch mode
Used to run downwards through the menu, or decrease the numerical values to be changed.
During the running phase of the pump: pressing one of two keys simultaneously together with the key
Once you set the stroke length, the pump will make 4 calibration strokes for the correct setting.
Flashing green LED during dosage
Red LED that lights up in various alarm situations
EM00136290
Control panel – GEA R MT
, you can increase
2
3 4 5 6
1
B
7 8 9
10
DosingPump.ir
or keys, it increases or decreases a value
or decrease the stroke length.
Electrical connections
rev. 1.0 EN
1
Alarm relay
2
4-20 mA input signal
3 Pole +
Input Impedante: 200
4 Pole - ohm
5
-Remote control input (start-stop)
-Pause signal input
6
7 -Frequency signal input (water-
meter pulse-sender)
8
-Trigger signal input
9
Flow sensor input
10
B Input level control
1