Craftsman 152.221040 Manual Del Propietário página 16

EXTENSION WiNG ASSEMBLY HANDWHEEL ASSEMBLY
MAKE CERTAIN the table saw is disconnected from
the power source.
The right extension wing must be completely assem-
bled and motor cover closed and fastened before table
saw is to be connected to the power source.
Figure 64 A
o _
2,
CAUTION: The extension wings are heavy; two
people are required to assemble both extension
wings to the table saw.
Assemble one of the extension wings (A) to the left
side of the table saw. Align the four holes (B) in the
extension wing with the four holes in the left side of
the saw table. Use four M8 x 30mm hex head
screws, M8 lock washers and M8 flat washers.
Do not completely tighten hardware at this time.
See figure 6-1.
Figure 6=2
MAKE CERTAIN the table saw is disconnected from
the power source.
Figure 7=1
C
B
1,
Place one of the handwheels (A) onto the bevel
shaft (B) located on the side of the cabinet. Align
the groove (C) in the back of the handwheel with
the pin (D). See figure 7-1.
Figure 7=2
3. Lay a straight edge (C) across the saw table (D)
and extension wing (E). Make sure that the front
face of the extension wing (F) is flat to the front
face of the saw table (G). Adjust the extension
wing so that its top surface is exactly flat to the saw
table and securely tighten hardware. See figure 6-2.
4. Repeat steps 2 and 3 above to assemble the other
extension wing to the right side of the table saw.
2,
3,
16
Thread the locking knob (E) onto the threaded end
of the shaft (F). See figure 7-2.
Repeat the steps above to assemble the remaining
handwheel and locking knob onto the blade raise/
lower shaft located on the front of the cabinet.