Hkoenig LVX26 Manual De Instrucciones página 6

-
Do not set up the device in a hot, wet or extremely damp environment or near flammable material.
-
The electrical socket must be easily accessible so that the power lead can be
disconnected easily, in the case of an emergency.
-
The installation and assembly of this device in non‐stationary setup locations (e.g. on ships) must
be carried out by specialist companies / electricians, provided they guarantee the prerequisites for
the safe use of this device.
Electrical connection
In order to ensure the safe and trouble‐free operation of the device, the following
instructions must be observed for the electrical connection:
•
Before connecting the device, compare the connection data (voltage and frequency) on the
rating plate with those of your electrical network. This data must agree in order that no damages
occur in the device
If in doubt, ask your qualified electrician.
•
The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross‐section of 1.5 mm². The use of multiple plugs or gangs is
prohibited because of the danger of fire that is involved with this.
•
Make sure that the power cable is undamaged and has not been installed under the oven or
over hot or sharp surfaces.
•
The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet without a
protective conductor are prohibited. If in doubt, have the house installation checked over by a
qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing or
damaged protective conductor.
Rating plate
The rating plate with the connection and performance data can be founded on the underside of the
device.
Operation and Handing
This chapter provides you with important notices with regard to operating the device. Observe the
following notices to avoid dangers and damages: