Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO USE YOUR PRESSURE
WASHER
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
Pressure Washer Location
Pressure Washer Clearance
WARNING
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
• Keep at least 5 ft. (152 cm) clearance on all sides of
pressure washer including overhead.
Place pressure washer outdoors. DO NOT place
pressure washer where exhaust gas could accumulate
and enter inside or be drawn into a potentially
occupied building. Ensure exhaust gas is kept away
from any windows, doors, ventilation intakes or other
openings that can allow exhaust gas to collect in a
confined area. Prevailing winds and air currents
should be taken into consideration when positioning
pressure washer.
WARNING
Running engine gives off carbon monoxide,
an odorless, colorless, poison gas.
Breathing carbon monoxide can cause
nausea, fainting or death.
• Operate pressure washer ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes or other openings.
• DO NOT operate pressure washer inside any building or
enclosure, even if doors or windows are open.
OPERATION
Typical Pressure
Washer Shown
Exhaust Port
9
To Start Your Pressure Washer
To start your engine-powered pressure washer for the
first time, follow these instructions step-by-step. This
starting information also applies whenever you start
the engine after you have let the pressure washer sit
idle for at least a day.
1. Place pressure washer near an outside water
source capable of supplying water at a flow rate
greater than 3.2 gallons per minute and no less than
20 PSI at pressure washer end of garden hose.
2. Check that high pressure hose is tightly connected
to spray gun and pump. See "Assembling Your
Pressure Washer" for illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure
washer pump.
5. Turn ON water, point gun in a safe direction and
squeeze trigger to purge pump system of air and
impurities.
CAUTION
DO NOT run the pump without the water supply
connected and turned on.
• Damage to equipment will result from failure to follow
this instruction.
6. Attach nozzle extension to spray gun. Tighten by
hand.
7. Choose ProjectPro™ nozzle you want to use, pull
back on collar of nozzle extension, insert nozzle
and release collar. Tug on nozzle to make sure it
is securely in place. See "How to Use
ProjectPro™ Nozzle System".
8. Engage trigger lock to spray gun trigger.
Trigger Lock
Publicidad
