Publicidad
Idiomas disponibles
Idiomas disponibles
Operation
2
Operating the sensor
NOTE: The sensor is active only when the handle is in the
ON position.
□
Turn the handle (1) away from the faucet to the
full on position. Turn the water on by activating
the sensor (2) by waving your hand within
2-3/8 inches of the sensor.
□
Move handle towards you and away from you,
the water ow pattern can be switched from
the hot water to cold water.
□
If the sensor does not work, then you can refer
to the troubleshooting. If you want to use the
faucet without the sensor feature, then you
can refer to step 6. Then, turning on the water
can be done by moving the handle away from
the faucet to the full on position.
NOTE: As a water saving feature, the water will turn off
automatically after 3 minutes of continuous ow.
3
Removing the quick connector
(not required)
□
If it is necessary to remove the quick connector
(1), squeeze the tabs (2) on the quick connector
and then pull down to disconnect.
Care and Cleaning
□
To clean, wipe down with a damp cloth and dry with a towel.
□
Do not use abrasive cleaners, steel wool, or harsh chemicals when cleaning this faucet, or the warranty will
be voided.
0
3
min.
45
15
30
Squeeze
1
13
Please contact 1-855-HD-GLACIER for further assistance.
Hot
2
1
2
Pull
down
1
HOMEDEPOT.COM/GLACIERBAY
Cold
Publicidad
