Kenmore 253 Serie Guia Del Propietario página 5

This Owner's Guide provides specific operating instructions
for your model, Use the refrigerator only as instructed in
this Owner's Guide, Before starting the refrigerator,
follow these important first steps.
LOCATION
• Choose a place that is near a grounded electrical
outlet, Do Not use an extension cord or an adapter
plug,
. If possible, place the refrigerator out of direct sunlight
and away from the range, dishwasher or other heat
sources,
• The refrigerator must be installed on a floor that is
level and strong enough to support a fully loaded
refrigerator
o Consider water supply availability for models equipped
with an automatic ice maker
INSTALLATION
• Do not install the refrigerator where temperature will
drop below 60"F (t5°C) or rise above 110°F (43°C).,
The compressor will not be abfe to maintain proper
temperatures
• In a recessed installation, allow an extra 1/2 inch
(10-15 mm) on each side, for ease of installation
• To permit proper door swing, if the hinge side of the unit
will be placed against a wall, allow a 1- 3/4 inch
(44 ram) space between the wall and the refrigerator,
DOOR OPENING
For best use of drawers and freezer basket, refrigerator
should be in a position where both refrigerator and freezer
doors can be opened about 135%
LEVELING
• Refrigerator must be leveled with ali bottom corners
resting firmly on a solid floor. Adjust front rollers to
level cabinet both front-to-rear and side-to-side. Keep
cabinet as low as possibie for stability. Never adjust
cabinet rollers so front is lower than rear.
• To adjust front rollers: Open refrigerator and freezer
doors. Remove toe grille by pulling it straight out.
Adjust rollers by turning each roller adjusting bolt with
an adjustable wrench, a socket wrench, or a nutdriver
until the refrigerator is level and stable.. Rear rollers
are not adjustable..
• Check both doors to ensure the seals touch the
cabinet evenly on all four corners.
* If freezer door is higher than refrigerator door,
raise right corner and/or lower left corner until doors
align across top of cabinet..
• If refrigerator door is higher than freezer door,
raise left corner and/or lower right corner untii doors
align across top of cabinet.
Roller Adjusting Bolt
Adjusting Front Rotlers
Replacing Toe Grille
° To replace toe grille: Line up tabs with holes, and
push grille straight on_
CLEANING
• Wash the inside, alt removable parts, and theoutside
with mild detergent and warm water Wipe dry° Do Not
use harsh cleaners on these surfaces.
• Do not use razor blades or other sharp instruments
that can scratch appliance surface, when removing
adhe sive labels.r Any glue left from tape or energy label
can be removed with a mixture of warm water and mild
detergent, or touch residue with sticky side of tape
already removed.
o Do not remove the Serial Plate,