OPERATION
IMPORTANT SAFETYINSTRUCTIONS
To reducethe risk of SEVERE INJURYor DEATH:
1. READAND FOLLOWALL WARNINGSAND INSTRUCTIONS.
2. ALWAYS keep remote controls out of reach of children.
NEVERpermit children to operate or play with garage door
control push buttons or remote controls.
3. ONLY activate garage door when it can be seen clearly, it is
properly adjusted, and there are no obstructions to door
travel.
4. ALWAYS keepgarage door in sight until completely closed.
NO ONESHOULDCROSSTHE PATH OFTHE MOVINGDOOR.
5. NO ONESHOULDGO UNDERA STOPPED,PARTIALLY
OPENEDDOOR.
6. If possible, use emergency release handle to disengage
trolley ONLY when garage door is CLOSED.Weak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly,causing SEVEREINJURY
or DEATH.
7. NEVERuse emergency releasehandle unless garage doorway
is clear of persons and obstructions.
8. NEVERuse handle to pull garage door open or closed. If rope
knot becomes untied, you could fall.
9. After ANY adjustments are made, the safety reversal system
MUST be tested.
10. Safety reversal system MUST be tested every month.
Garage door MUST reverse on contact with 1-1/2" high
(3.8 cm) object (or a 2x4 laid flat) on the floor.
11. ALWAYS KEEPGARAGEDOORPROPERLYBALANCED(see
page 3). An improperly balanced door may NOT reverse
when required and could result in SEVEREINJURY or
DEATH.
12. ALL repairs to cables, spring assemblies and other
hardware, ALL of which are under EXTREME tension, MUST
be made by a trained door systems technician.
13. To avoid SERIOUSPERSONALINJURYor DEATHfrom
electrocution, disconnect ALL electric and battery power
BEFORE performing ANY service or maintenance.
14. This operator system is equipped with an unattended
operation feature. The door could move unexpectedly. NO
ONESHOULDCROSSTHE PATH OFTHE MOVINGDOOR.
15. DONOT enable the Timer-to-Close functionality if operating
either one-piece or swinging garage doors. To be enabled
ONLYwhen operating a sectional door.
16SAVETHESEINSTRUCTIONS.
Features
Your garage door opener is equipped with features to provide you
with greater control over your garage door operation.
TIMER-TO-CLOSE
The Timer-to-Close feature automatically closes the door after a
specified time period that can be adjusted using the door control.
Prior to the door closing there will be an audible and visual alert.
ASSURELINK
TM
AssureLink
TM
technology uses a 900MHz signal to provide
two-way communication between the garage door opener and
AssureLink
TM
accessories. Your garage door opener is compatible
with up to 8 AssureLink
TM
accessories.
REMOTECONTROLS AND DOORCONTROLS
Your garage door opener is compatible with up to 2 door controls.
Your garage door opener has already been programmed at the
factory to operatewith your remote control, which changes with
each use, randomly accessing over 100 billion new codes. The
garage door opener is compatible with up to 8 remote controls
and 1 keyless entry.
THE PROTECTOR SYSTEM ® (SAFETYREVERSING SENSORS)
When properly connected and aligned, the safety reversing
sensors will detect an obstruction in the path of the infrared
beam. If an obstruction breaks the infrared beamwhile the door is
closing, the door will stop and reverse to full open position, and
the opener lights will flash 10 times. If the door is fully open, and
the safety reversing sensors are not installed, or are misaligned,
31
the door will not close from a remote control. However,you can
close the door if you hold the button on the door control or
keyless entry until the door is fully closed. The safety reversing
sensors do no effect the opening cycle.
ENERGYCONSERVATION
For energy efficiency the garage door opener will enter sleep
mode when the door is fully closed. The sleep mode shuts the
garage door opener down until activated. The sleep mode is
sequenced with the garage door opener light bulb; as the light
bulb turns off the sensor LEDswill turn off and whenever the
garage door opener lights turn on the sensor LEDs will light.
The garage door opener will not go into the sleep mode until the
garage door opener has completed 5 cycles upon power up.
LIGHTS
The garage door opener light bulbs will turn on when the opener
is initially plugged in; power is restored after interruption, or
when the garage door opener is activated. The lights will turn off
automatically after 4-1/2 minutes. An incandescent A19 light bulb
(100 watt maximum) or for maximum energy efficiency a 26W
(100W equivalent) compact fluorescent light (CFL) bulb may
be used.
The garage door opener is equipped with an added feature; the
lights will turn on when someone enters through the open garage
door and the safety reversing sensor infrared beam is broken.
For added control over the light bulbs on your garage door
opener, see the Door Control section.